3.53 [1-1] Slot—Card Property - IP Extension—Common SettingsIP-PT network data transmission settings can be programmed. To activate any changes made to settings onthis screen, it is necessary to set all installed IP-EXT cards to OUS, then back to INS.Gateway AddressSpecifies the default gateway address of the network for IP-PTs.Value Range0.0.0.0–223.255.255.255Maintenance Console Location3.53 [1-1] Slot—Card Property - IP Extension—Common SettingsProgramming Manual References3.52 [1-1] Slot—Card Property - IP Extension— Gateway Address [Common Settings]Feature Guide References1.31.1 IP Proprietary Telephone (IP-PT)Voice (RTP) UDP Port No. (Server)Specifies the UDP port used by the IP-EXT card to transmit and receive RTP (Realtime Transfer Protocol)data. This must be changed if another network application is using the same port.For voice communications, an IP-EXT card uses 64 contiguous UDP ports, starting from the port numberspecified here.Value Range1024–65472Maintenance Console Location3.53 [1-1] Slot—Card Property - IP Extension—Common SettingsProgramming Manual ReferencesNoneFeature Guide References1.31.1 IP Proprietary Telephone (IP-PT)Voice (RTP) UDP Port No. (IP-PT)Specifies the UDP port used to transmit and receive RTP (Realtime Transfer Protocol) data on the IP-PT side.This must be changed if another network application is using the same port.410 PC Programming Manual3.53 [1-1] Slot—Card Property - IP Extension—Common Settings
