33KX-TDE200GR8 Test Mode8.1. Utility8.1.1. Utility-DiagnosisPerforms diagnostic tests on cards installed in the PBX, to identify the source of problems. There are 2 types of test, Card Test andPair Port Test.If any of the tests listed here returns the result "NG" ("No Good"), contact your dealer. Test results can be saved as a TXT-format(text) file.When testing is complete, any cards that were set to OUS status must be returned to INS status if they are to be used again.8.1.1.1. Card TestTests the relevant functions of a card to ensure that it is operating correctly. The tests carried out vary according to the type ofcard being tested.The tests that are performed on each card are as follows:A check mark indicates that the test is available for that card.To perform a card test1. From the Utility menu, select Diagnosis.2. Click on the Status cell of the card to be tested, and set it to "OUS".3. Click on the cell showing the card type.A new window will be displayed.4. Select the Card Test option.A new window will be displayed.5. Click OK to perform the test(s).The error report will be displayed. When all tests are completed, the words "Test End!" will be shown on the last line of the out-put.6. Select an option:• Click Capture if you want to save the displayed information.1. Enter a file name, or select a file to overwrite.2. Click Save.• Click Cancel to return to the Diagnosis screen.DHLC DLC SLC8 SLC16/MSLC16CSIF LCOT T1 E1 BRI PRI OPB E&M DID IP-GW4(TDA0484)IP-GW16IP-EXTLocal loop back diagnosis X X X X X X X X X X X X X XCard CT bus diagnosis X X X X X X X X X X X X X XDTMF Receive test port X X X X XPT loop back diagnosis X XCaller ID Card DTMF SendingOut DiagnosisXDSP DTMF generator/receiverdiagnosisX XDSP DTMF receiver diagnosis X XFramer IC alarm signal detec-tion diagnosisX X XFramer IC error detection diag-nosisX X XCS-INF loop back diagnosis XSuper frame synchronizationdiagnosisXCaller ID card loop back diag-nosisXExtension mode setting test XIP-GW H.323 call simulatediagnosisX XLAN loop back diagnosis X