Panasonic KX-TG1805NZ Operating Instructions Manual

Panasonic KX-TG1805NZ Operating Instructions Manual Manual pdf 29 page image

Multi-unit Operation295 Wait until “Enter Base PIN” isdisplayed, then enter “0000” (defaultbase unit PIN), then press {j/OK}.L If you changed the PIN, enter it (page25).L When the handset has beenregistered successfully, w will stopflashing. If keytones are turned on(page 19), a confirmation tone will beheard.Cancelling a handsetA maximum of 6 handsets can be registeredto a base unit. A handset can cancel its ownregistration (or the registration of anotherhandset) that is stored in the base unit. Thiswill allow the base unit to “forget” thehandset.1 Press {j/OK}.2 Select “Base Unit Setup”, thenpress {>}.3 Enter “0000” (default base unit PIN).L If you changed the PIN, enter it (page25).4 Enter “335”.5 Select “Cancel Handset”, then press{>}.L The numbers of all handsetsregistered to the base unit aredisplayed.6 Select the handset(s) you want tocancel, by pressing the desired handsetnumber.L The selected handset number(s) willflash.L To cancel a selected handset number,press the number again. The numberwill stop flashing.7 Press {j/OK}.8 Select “Yes”, then press {>}.9 Press {ih}.Cancelling a base unitA handset can cancel a base unit that it isregistered to. This allows the handset to“forget” the base unit.1 Press {j/OK}.2 Select “Handset Setup”, then press{>}.3 Select “Registration”, then press{>}.4 Enter “335”.5 Select “Cancel Base”, then press{>}.6 Enter “0000” (default handset PIN).L If you changed the PIN, enter it (page19).7 Select “Yes”, then press {>}.8 Press {ih}.Note:L If you cancel the base unit from thehandset’s memory, you cannot use thehandset to make calls or perform otheroperations. To use the handset again, youmust first register it to a base unit (page28).Increasing the range of the baseunitYou can increase the range of the base unitby using a DECT repeater. Please use onlythe Panasonic DECT repeater noted onpage 4. Consult your Panasonic dealer fordetails.Important:L Before registering the repeater to thisbase unit, you must turn the repeatermode on.Turning the repeater mode on/off1 Press {j/OK}.2 Select “Base Unit Setup”, thenpress {>}.