Voice Mail Service32Turning VM detection on/off1 Press {MENU}.2 Scroll to “Initial setting” bypressing {V} or {^}, then press {>}.3 Scroll to “Voice Mail” by pressing {V}or {^}, then press {>}.4 Scroll to “VM tone detect” bypressing {V} or {^}, then press {>}.5 Press {V} or {^} repeatedly to select“On” or “Off”.6 Press {Save}, then press {OFF}.Listening to Voice MailmessagesThe unit will let you know that you havenew Voice Mail messages in the followingways:– “Voice Mail” will be displayed on thehandset.– The message indicator on the handsetwill flash slowly if message alert featureis turned on.1 Press {C} or {s}, then press {VM}within 15 seconds.L If {VM} is not displayed, the VoiceMail access number has not beenstored. Store the number (page 31).ORPress {MENU}, then press {Select} at“V.M. access”.L The speakerphone will turn on.2 Follow the pre-recorded instructions.3 Press {OFF} when finished.Note:L If “Voice Mail” still remains on thedisplay even after you have listened tonew messages, turn it off by pressingand holding {OFF} until the handsetbeeps.L If your Voice Mail service uses VoiceMail tones and the message is over 3minutes long, the handset may notindicate new messages.L If your Voice Mail service uses VoiceMail tones, the tones will be heard fromany phone connected to the same line. Ifyou want to use another phone to listento Voice Mail messages, you have to dialyour access number manually.Message alertYou can select whether or not themessage indicator on the handset willflash when new messages have beenrecorded. The default setting is OFF.1 Press {MENU}.2 Scroll to “Initial setting” bypressing {V} or {^}, then press {>}.3 Scroll to “Message alert” by pressing{V} or {^}, then press {>}.4 Press {V} or {^} repeatedly to select“On” or “Off”.5 Press {Save}, then press {OFF}.Note:L The message indicator will not flash fornew messages while the handset is inuse.L While message alert is on, batteryoperating time will be shortened (page12).TG2421C_2424C(e).book Page 32 Wednesday, December 22, 2004 6:54 PM