Useful Information48Call DisplayCopying stopped with anitem displayed.L The destination handset may have lost communicationwith the base unit, or the destination handset user mayhave pressed {C} or {s}.The displayed phonebook item was not copied to thehandset. Press {OFF}. Confirm that the destinationhandset is in standby mode (i.e., not in use) and tryagain.The display exits thephonebook whilesearching.L The handset automatically exits after 1 minute ofinactivity.Problem Cause & solutionThe handset does notdisplay the caller’s nameand/or phone number.L You have not subscribed to Call Display service.Contact your telephone company to subscribe.L If your unit is connected to any additional telephoneequipment such as a Call Display box or wirelesstelephone jack, disconnect the unit from the equipmentand plug the unit directly into the wall jack.L If your unit is connected to a telephone line with xDSLservice, we recommend connecting a noise filterbetween the base unit and the telephone line jack.Contact your xDSL provider for details.L The name display service may not be available in someareas. Contact your telephone company for details.L Other telephone equipment may be interfering with thisunit. Disconnect the other equipment and try again.L The caller requested not to send caller information(page 26).L If a call is being transferred to you, the caller informationwill not be displayed.L Generally caller information is displayed from the 2ndring.I cannot dial the phonenumber edited in thecaller list.L The phone number you dialed might have an incorrectedited pattern (for example, the long distance “1” or thearea code is missing). Edit the phone number withanother pattern (page 27).The display exits thecaller list while searching.L The handset automatically exits after 1 minute ofinactivity.Problem Cause & solutionTG2421C_2424C(e).book Page 48 Wednesday, December 22, 2004 6:54 PM