Useful Information49Industry Canada Notices and other informationNOTICE:This equipment meets the applicable IndustryCanada Terminal Equipment TechnicalSpecifications. This is confirmed by theregistration number. The abbreviation, “IC:”,before the registration number signifies thatregistration was performed based on aDeclaration of Conformity indicating thatIndustry Canada technical specifications weremet. It does not imply that Industry Canadaapproved the equipment. And, the term “IC:”signifies that Industry Canada radio technicalspecifications were met.Before installing this equipment, users shouldensure that it is permissible to be connectedto the facilities of the localtelecommunications company. The equipmentmust also be installed using an acceptablemethod of connection. The customer shouldbe aware that compliance with the aboveconditions may not prevent degradation ofservice in some situations.Repairs to certified equipment should becoordinated by a representative designatedby the supplier. Any repairs or alterationsmade by the user to this equipment, orequipment malfunctions, may give thetelecommunications company cause torequest the user to disconnect the equipment.requirement that the sum of the RingerEquivalence Numbers of all the devices doesnot exceed 5.The Ringer Equivalence Number (REN) of thisunit: (found on the bottom of the unit).NOTICE:Operation is subject to the following twoconditions: (1) this device may not causeinterference, and (2) this device must acceptany interference, including interference thatmay cause undesired operation of the device.Privacy of communications may not beensured when using this telephone.Some cordless telephones operate atfrequencies that may cause interference tonearby TVs and VCRs. To minimize or preventsuch interference, the base of the cordlesstelephone should not be placed near, or on topof, a TV or VCR. If interference is experienced,move the cordless telephone further awayfrom the TV or VCR. This will often reduce, oreliminate, interference.RF Exposure Warning:NOTICE:The Ringer Equivalence Number (REN)assigned to each terminal device provides anindication of the maximum number of terminalsallowed to be connected to a telephoneinterface.The termination on an interface may consist ofany combination of devices subject only to theUsers should ensure, for their own protection,that the electrical ground connections of thepower utility, telephone lines and internalmetallic water pipe system, if present, areconnected together. This precaution may beparticularly important in rural areas.Caution:Users should not attempt to make suchconnections themselves, but should contact theappropriate electric inspection authority, orelectrician, as appropriate.L This product complies with IC radiationexposure limits set forth for an uncontrolledenvironment.L To comply with IC RF exposure requirements,the base unit must be installed and operated20 cm (8 inches) or more between productand all person’s body (excluding extremitiesof hands, wrist and feet).L This product may not be collocated oroperated in conjunction with any otherantenna or transmitter.L The handset may be carried and operatedwith only the specific provided belt-clip. Othernon-tested belt-clips or similar body-wornaccessories may not comply and must beavoided.TG74xxC(e).book Page 49 Monday, February 16, 2009 1:44 PM