SMS (Short Message Service)36Note:L To call the message sender, press{C}.Replying to a message1 While reading a received message,press 1.2 {V}/{^}: “Reply” i M3 Enter a message (page 44). iM4 Edit the destination phone number ifnecessary. i M5 Continue from step 5, “Writing andsending a new message”, page 34.Editing/forwarding a message1 While reading a received message,press 1.2 {V}/{^}: “Edit Message” i M3 Continue from step 3, “Writing andsending a new message”, page 34.Erasing received messages1 While reading a received message,press 1.2 {V}/{^}: “Erase” i ML To erase all messages, select“Erase All”. i M3 {V}/{^}: “Yes” i M i {ic}Storing the sender’s numberin the phonebook1 While reading a received message,press 1.2 {V}/{^}: “Add Phonebook” iM3 To store the name, continue fromstep 2, “Adding entries”, page 19.Editing the sender’s numberbefore calling back1 While reading a received message,press 1.2 {V}/{^}: “Edit & Call” i M3 Edit the number. i {C}Other settingsStoring the PBX line accessnumber (for PBX users only)Store your PBX line access number (4digits max.) so that SMS messages aresent properly. When sending SMSmessages to entries in the phonebook orredial list, the PBX line access number isdeleted. The default setting is “Off”.1 1 i {#}{3}{5}{6}2 {V}/{^}: “On” i M3 Enter your PBX line access codeand a dialling pause, if necessary.i M i {ic}TG7511_7521BX(e).book Page 36 Tuesday, June 15, 2010 2:10 PM