Panasonic KX-TG7731C Operating Instructions Manual

Contents

Panasonic KX-TG7731C Operating Instructions Manual Manual pdf 41 page image

Special programmingAlarmAn alarm sounds at the set time for 3 minutesonce or daily. Alarm can be set for eachhandset.Important:R Set the date and time beforehand(page 17).1 MMENUN#7202 MbN: Select the desired alarm option. aMSELECTNOff Turns alarm off. Go to step 7.Once An alarm sounds once at theset time.Daily An alarm sounds daily at theset time. Go to step 4.3 Enter the desired month and date. aMOKN4 Set the desired time.5 MAM/PMN: Select “AM” or “PM”. a MOKN6 MbN: Select the desired alarm tone. aMSELECTNR We recommend selecting a differentringer tone from the one used foroutside calls.7 MSELECTN a MOFFNR When the alarm is set, is displayed.Note:R To stop the alarm, press MOFFN or placethe handset on the base unit or charger.R When the handset is in use, the alarm willnot sound until the handset is in standbymode.Night modeNight mode allows you to select a period oftime during which the handset will not ring foroutside calls. This feature is useful for timeperiods when you do not want to be disturbed,for example, while sleeping. Night mode canbe set for each handset.Important:R Set the date and time beforehand(page 17).R We recommend turning the base unit ringeroff (page 36, 38) in addition to turning thenight mode on.R If you have set the alarm, the alarm soundseven if the night mode is turned on.Turning night mode on/off1 MMENUN#2382 MbN: Select the desired setting. aMSAVENR If you select “Off”, press MOFFN toexit.3 Enter the desired hour and minute youwish to start this feature.4 MAM/PMN: Select “AM” or “PM”. a MOKN5 Enter the desired hour and minute youwish to end this feature.6 MAM/PMN: Select “AM” or “PM”.7 MSAVEN a MOFFNR When the night mode is set, isdisplayed.Changing the start and end time1 MMENUN#2372 Continue from step 3, “Turning nightmode on/off”, page 41.Changing the handset nameEach handset can be given a customizedname (“Bob”, “Kitchen”, etc.). This is usefulwhen you make intercom calls betweenhandsets. You can also select whether or notthe handset name is displayed in standbymode. The default setting is “No”. If you select“Yes” without entering any handset name,“Handset 1” to “Handset 6” is displayed.1 MMENUN#10441ProgrammingTG7731_41C_(en-en)_1207_ver.021.41 41 2011/12/07 19:54:00