Answering System43Erasing all messages1 1 (middle soft key) y3252 {r}: “Yes” s M s {ic}Remote operationUsing a touch-tone phone, you can call yourphone number from outside and access theunit to listen to messages or changeanswering system settings.Remote access codeA 3-digit remote access code must be enteredwhen operating the answering systemremotely. This code prevents unauthorisedparties from listening to your messagesremotely.Important:L In order to operate the answering systemremotely, you must first set a remote accesscode.1 1 (middle soft key) y3z62 To turn on remote operation, enter thedesired 3-digit remote access code.3 M s {ic}Deactivating remote operationPress * in step 2 on “Remote access code”,page 43.L The entered remote access code is deleted.Using the answering systemremotely1 Dial your phone number from a touch-tone phone.2 After the greeting message starts, enteryour remote access code.3 Enter remote commands.4 When finished, hang up.Remote commands*1 If pressed within the first 5 seconds of amessage, the previous message is played.Turning on the answering systemremotelyIf the answering system is off, you can turn iton remotely.1 Dial your phone number from a touch-tone phone.2 Let the phone ring 9 times.L A long beep is heard.3 Enter your remote access code within 10seconds after the long beep.L The greeting message is played back.L You can either hang up, or enter yourremote access code again and beginremote operation (page 43).Key Operation1 Repeat message(during playback)*12 Skip message(during playback)4 Play new messages5 Play all messages6 Play greeting message7 Record greeting message9 Stop recordingStop playbackz Turn answering system off*4 Erase currently playingmessage*5 Erase all messages*6 Reset to a pre-recordedgreeting message (duringgreeting message playback)*y End remote operation(or hang up)TG8051_8061FX(e-e).book Page 43 Monday, April 25, 2011 11:42 AM