Error messagesDisplay message Cause/solutionBase no powerorNo link to base.Reconnect main baseAC adaptor.orNo link.R The handset has lost communication with the base unit. Movecloser to the base unit and try again.R Unplug the base unit’s AC adaptor to reset the unit. Reconnectthe adaptor and try again.R The handset’s registration may have been cancelled.Re-register the handset (page 40).R When “No link.” is displayed during a power failure, placea handset on the base unit to supply power to the base unit.Check Phone Line R The supplied telephone line cord has not been connected yetor not connected properly. Check the connections (page 10).Error R Recording was too short. Try again.Failed R Phonebook copy failed (page 24). Confirm the other handset(the receiver) is in standby mode and try again.Incomplete R The receiver’s phonebook memory is full. Erase the unwantedphonebook entries from the other handset (the receiver) andtry again.Invalid Number R You tried to send an SMS message to a phone number savedin the phonebook, caller list, or redial list that is over 20 digitslong.Memory Full R The phonebook memory is full. Erase unwanted entries(page 24).R Message memory is full. Erase unwanted messages (page 48,49).R The call barred list memory is full. Erase unwanted entries(page 35).R The schedule alarm memory is full. Erase unwanted entries(page 37).R The maximum number of base units (4) is already registeredto the handset. Cancel unused base unit registrations from thehandset (page 40).Use rechargeablebattery.R A wrong type of battery such as Alkaline or Manganese wasinserted. Use only the rechargeable Ni-MH batteries noted onpage 4, 7.You must firstsubscribe to CallerID.R You must subscribe to a Caller ID service. Once you receivecaller information after subscribing to a Caller ID service, thismessage will not be displayed.57Useful InformationTG8551_61FX_(en-en)_0427_ver021.57 57 2012/04/27 20:24:48