Preparation14Battery strengthPanasonic Ni-MH battery performance(included batteries)Note:L It is normal for batteries not to reach fullcapacity at the initial charge. Maximumbattery performance is reached after a fewcomplete cycles of charge/discharge(use).L Actual battery performance depends on acombination of how often the handset is inuse and how often it is not in use(standby).L Battery operating time may be shortenedover time depending on usage conditionsand ambient temperature.L Even after the handset is fully charged,the handset can be left on the base unitwithout any ill effect on the batteries.L The battery strength may not be displayedcorrectly after you replace the batteries. Inthis case, place the handset on the baseunit and charge for at least 7 hours.Screen saver modeThe backlight will turn off completelyafter 1 minute of inactivity if the handset isnot on the base unit.To use the handset when it is in screensaver mode, first press {ih} to turn thedisplay on again.Turning the power on/offPower onPress {ih} until a short beep sounds.Power offPress {ih} for about 2 seconds.Symbols used in theseoperating instructionsRegion settingsYou can set the unit to use settings thatmatch your country (page 35). The displaylanguage and other settings will changeaccordingly.Battery icon Battery strength@ High? Medium/ LowWhen flashing: Needsto be charged.Operation Operating timeIn continuous use 15 hours max.In continuousstandby mode240 hours max.Symbol MeaningJ Press J (centre of joystick).i Proceed to the next operation.L Press L (centre of joystick).jXIM3mLSelect the mentioned handsetmenu icon (page 11).Example: m (handset setupmenu icon)Select m by pushing thejoystick in any direction.“ ” Select the words in quotationsshown on the display (e.g.,“Time Settings”) bypushing the joystick up ordown.TG9120_40_50EX(e).book Page 14 Monday, August 7, 2006 3:52 PM