Panasonic KX-TG9120EX Operating Instructions Manual

Panasonic KX-TG9120EX Operating Instructions Manual Manual pdf 55 page image

Multi-unit Operation55L This number is used by the handsetas a reference only.5 Press and hold {x} on the base unit forabout 3 seconds, until the registrationtone sounds.L If all registered handsets start ringing,press {x} to stop, then repeat thisstep.L After pressing {x}, the rest of thisprocedure must be completed within 1minute.6 Wait until “Enter Base PIN” isdisplayed, then enter the base unit PIN(default: “0000”), then press L.L When the handset has beenregistered successfully, w will stopflashing. If keytones are turned on(page 31), a confirmation tone will beheard.Selecting a base unitWhen “Auto” is selected, the handset willautomatically use any available base unit itis registered to. When a specific base unit isselected, the handset will make and receivecalls using that base unit only. If the handsetis out of range of that base unit, no calls canbe made.1 J (centre of joystick) i m i L2 “Select Base” i L3 Select the desired base unit number, or“Auto”. i LL The handset starts searching for thebase unit.Cancelling a handsetA maximum of 6 handsets can be registeredto a base unit. A handset can cancel its ownregistration (or the registration of anotherhandset) that is stored in the base unit. Thiswill allow the base unit to “forget” thehandset.1 J (centre of joystick) i L i L2 Enter “335”.3 “Cancel Handset” i LL All handsets registered to the baseunit are displayed.4 Select the handset(s) you want tocancel. i tL The selected handsets are indicatedby a “Q”.L To cancel a selected handset, presst again.5 L i “Yes” i LL “Please Wait...” will be displayedand a long beep will sound.L The handset does not beep whencancelling its own registration.6 {ih}Cancelling a base unitA handset can be registered to a maximumof 4 base units. A handset can cancel a baseunit that it is registered to. This allows thehandset to “forget” the base unit.1 J (centre of joystick) i m i L2 “Registration” i L3 Enter “335”.4 “Cancel Base” i L5 Select the base unit(s) you want tocancel. i tL The selected base unit number(s) areindicated by a “Q”.L To cancel a selected base unitnumber, press t again.6 L i “Yes” i LL A long beep will sound.7 {ih}Note:L To register the handset to another baseunit or to the same base unit again, seemanual registration (page 54).TG9120_40_50EX(e).book Page 55 Monday, August 7, 2006 3:52 PM