Multi-unit Operation56Increasing the range of the baseunitYou can increase the signal range of thebase unit by using a DECT repeater. Pleaseuse only the Panasonic DECT repeaternoted on page 7. Consult your Panasonicdealer for details.Important:L Before registering the repeater to thisbase unit, you must turn the repeatermode on.L Do not use more than one repeater at atime.L You cannot make a monitoring connectionvia a DECT repeater. (Cordless cameraKX-TGA914EX users only)Setting the repeater mode1 J (centre of joystick) i L iL2 “Other Options” i L3 “Repeater Mode” i L4 “On” i L i {ih}Note:L After turning repeater mode on or off, wwill flash on the handset momentarily. Thisis normal. The handset can be used oncew stops flashing.L While the repeater mode is turned on,audible call announcements may not beheard from the handset speaker.Intercom betweenhandsetsIntercom calls can be made betweenhandsets in the same radio cell.Example: When handset 1 calls handset 21 Handset 1:{INT} i Select handset 2 (desiredhandset number). i P / {C} / {s}2 Handset 2:Press {C} / {s} to answer.3 When finished talking, press {ih}.Transferring callsbetween handsets,conference callsOutside calls can be transferred between 2people in the same radio cell. 2 people in thesame radio cell can have a conference callwith an outside party.Example: When handset 1 transfers a callto handset 21 Handset 1:During an outside call, press {INT}. iSelect handset 2 (desired handsetnumber). i P / {C} / {s}L The outside call will be put on hold.L If there is no answer, press {INT} toreturn to the outside call.2 Handset 2:Press {C} / {s} to answer the page.L Handset 2 can talk with handset 1.3 Handset 1:To complete the call transfer, press{ih}.To establish a conference call, pressw.Transferring a call without speaking tothe other handset user1 During an outside call, press {INT}. iSelect the desired handset number. iP / {C} / {s}L k flashes to indicate the outside callis on hold.2 {ih}TG9120_40_50EX(e).book Page 56 Monday, August 7, 2006 3:52 PM