Panasonic KX-TG9581 Operating Instructions Manual

Contents

Playing back the greeting messageHandset / Base unit1 For line 1: MMENUN#3031For line 2: MMENUN#30322 MbN: Select the desired greeting message. aMSELECTN3 Proceed with the operation for your unit.Handset: To exit, press MOFFN.Base unit: To exit, press MEXITN.Listening to messagesUsing the base unitWhen new messages have been recorded:– M N on the base unit flashes.– “New message: ” and/or “New message:” is displayed.For line 1: Press M N (PLAY1).For line 2: Press M N (PLAY2).R If new messages have been recorded, the baseunit plays back new messages.R If there are no new messages, the base unitplays back all messages.Operating the answering system duringplaybackKey OperationMDN or MCN Adjust the speaker volumeM N Repeat message*1M N Skip messageMPAUSEN Pause messageTo resume playback, pressM N.M N (Stop) Stop playbackMERASEN Erase currently playing message*1 If pressed within the first 5 seconds of amessage, the previous message is played.Calling back (Caller ID subscribers only)Lift the corded handset.R To edit the number before calling back, pressMEDITN repeatedly until the phone number isshown in the desired format (page 55).R The unit automatically uses the line you set inline selection mode (page 18) to call back.When the line selection mode is set to “Auto”,the indicated line ( or ) is used for the call.If the indicated line is already being used or youwant to select the other line, press MLINE 1N orMLINE 2N, then lift the corded handset.R To call back using a cellular line, continue fromstep 2, “Making cellular calls”, page 27.Erasing all messages for the desired line1 MERASEN2 MbN: Select the desired line. a MSELECTN3 MbN: “Yes” a MSELECTNUsing the handsetWhen new messages have been recorded, “Newmessage” is displayed.1 To listen to new messages:For line 1: MPLAY1N*1, *2For line 2: MPLAY2N*1, *2orFor line 1: MMENUN#3231For line 2: MMENUN#3232To listen to all messages:For line 1: MMENUN#3241For line 2: MMENUN#32422 When finished, press MOFFN.Note:R To switch to the receiver, press M N.*1 If there are new messages in both lines,MPLAYN is displayed. Play the message asfollows:MPLAYN a MbN: Select the desired line. aMSELECTN*2 If there are no new messages in theanswering system, MPLAY1N, MPLAY2N, orMPLAYN is not displayed.Operating the answering systemMMENUN a MbN: “Answering device” aMSELECTN a MbN: Select the desired line. aMSELECTNKey OperationMDN or MCN Adjust the receiver/speaker volume(during playback)1 or MFN Repeat message (duringplayback)*1For assistance, please visit http://www.panasonic.com/help 63Answering System for LandlineTG958x_0704_ver031.pdf 63 2014/07/04 10:32:28