Panasonic KX-TGE432 Operating Instructions Manual

Also see for KX-TG3634: Operating instructions

2 MbN: Select the desired setting. aMSAVENR If you select “Off”, press MOFFN toexit.3 Enter the desired hour and minute youwish to start this feature.4 *: Select “AM” or “PM”. a MOKN5 Enter the desired hour and minute youwish to end this feature.6 *: Select “AM” or “PM”.7 MSAVEN a MOFFN*1 KX-TGE440 series: page 3Changing the start and end time1 For handset setting: MMENUN#237For base unit setting (using ahandset)*1: MMENUN#*2372 Continue from step 3, “Turning silentmode on/off”, page 34.*1 KX-TGE440 series: page 3Selecting groups to bypass silentmode1 For handset setting: MMENUN#241For base unit setting (using ahandset)*1: MMENUN#*2412 MbN: Select the desired groups. aMSELECTNR “ ” is displayed next to the selectedgroup numbers.R To cancel the selected group:MbN: Select the group. a PressMSELECTN again. “ ” disappears.3 MSAVEN a MOFFN*1 KX-TGE440 series: page 3Baby monitorThis feature allows you to listen in on a roomwhere another handset is located, allowingyou to easily monitor from different areas ofthe house or even while away from home. Themonitored handset (placed in a baby’s room,for example) will automatically call themonitoring handset, base unit, or the phonenumber stored when it detects sound.Important:R Before using this feature, we recommendthat you test this feature and adjust thebaby monitor sensitivity as needed,especially if you plan to monitor fromoutside.R This feature should not be used as asubstitute for a medical or caregiver’ssupervision. It is the caregiver’sresponsibility to stay close enough tohandle any eventuality.Note:R If the unit is connected to a PBX system,you cannot set the baby monitor.R During the monitoring mode, batteryconsumption is faster than usual. Werecommend leaving the monitored handseton the base unit or charger.R The monitored handset never rings while itis being monitored. If the base unit isplaced near the monitored handset, werecommend turning off the base unit ringervolume (page 17).Setting the baby monitorPerform the setting operation with the handsetto be monitored (for example, the handsetplaced in a baby’s room).To monitor with a unitThe internal baby monitor feature is available:– between handsets– between a handset and the base unit*1*1 KX-TGE440 series: page 31 MMENUN#2682 MbN: “On” a MSELECTN3 MbN: Select the desired unit’s number tomonitor with. a MSAVENR “Baby monitor” will be displayed.R The registered unit’s name/number isdisplayed.For assistance, please visit http://shop.panasonic.com/support 35ProgrammingTGE43xUS(en)_1112_ver021.pdf 35 2015/11/12 10:12:57