Battery rechargeProblem Cause/solutionThe handset beeps and/orflashes.R Battery charge is low. Fully charge the batteries (page 11).I fully charged the batteries, but– still flashes,– is displayed, or– the operating time seems tobe shorter.R Clean the battery ends ( , ) and the charge contactswith a dry cloth and charge again.R It is time to replace the batteries (page 10).Making/answering calls, intercomProblem Cause/solutionis displayed. R The handset is too far from the base unit. Move closer.R The base unit’s AC adaptor is not properly connected.Reconnect AC adaptor to the base unit.R The handset is not registered to the base unit. Register it(page 37).Noise is heard, sound cuts inand out.R You are using the handset or base unit in an area withhigh electrical interference. Re-position the base unit anduse the handset away from sources of interference.R Move closer to the base unit.R If you use a DSL/ADSL service, we recommendconnecting a DSL/ADSL filter between the base unit andthe telephone line jack. Contact your DSL/ADSL providerfor details.The handset does not ring. R The ringer volume is turned off. Adjust the ringer volume(page 17, 30).R Silent mode is turned on. Turn it off (page 34).The base unit does not ring. R The ringer volume is turned off. Adjust the ringer volume(page 17).R Silent mode is turned on. Turn it off (page 34).I cannot make a call. R The dialing mode may be set incorrectly. Change thesetting (page 15).I cannot make or answer a call. R An outside line is being used after a cell locator feature isused.– KX-TGE430 series: To end the call, press MLOCATESCELLN on the base unit.– KX-TGE440 series: To end the call if someoneanswers using the cellular phone, press MZN on thebase unit.I cannot make long distancecalls.R Make sure that you have long distance service.For assistance, please visit http://shop.panasonic.com/support 53Useful InformationTGE43xUS(en)_1112_ver021.pdf 53 2015/11/12 10:12:58