Panasonic KX-TGE432 Operating Instructions Manual

Also see for KX-TG3634: Operating instructions

Answering system settingsCall screeningHandset / Base unitWhile a caller is leaving a message, you canlisten to the call through the unit’s speaker.To adjust the speaker volume, press MjN orMkN repeatedly.You can answer the call by pressing M N onthe handset or MZN on the base unit*1.Call screening can be set for each unit. Thedefault setting is “On”.1 For handset setting: MMENUN#310For base unit setting (using ahandset)*1: MMENUN#*3102 MbN: Select the desired setting. aMSAVEN a MOFFN*1 KX-TGE440 series: page 3Number of rings before the unitanswers a callYou can change the number of times thephone rings “Ring count” before the unitanswers calls. You can select 2 to 7 rings, or“Toll saver”.The default setting is “4 rings”.“Toll saver”: The unit’s answering systemanswers at the end of the 2nd ring when newmessages have been recorded, or at the endof the 5th ring when there are no newmessages. If you call your phone from outsideto listen to new messages (page 45), youknow that there are no new messages whenthe phone rings for the 3rd time. You can thenhang up without being charged for the call.1 MMENUN#2112 MbN: Select the desired setting. aMSAVEN a MOFFNCaller’s recording timeYou can change the maximum messagerecording time allowed for each caller. Thedefault setting is “3 min”.1 MMENUN#3052 MbN: Select the desired setting. aMSAVEN a MOFFNSelecting “Greeting only”You can select “Greeting only” which setsthe unit to announce a greeting message tocallers but not record messages.Select “Greeting only” in step 2 on“Caller’s recording time”, page 46.Note:R When you select “Greeting only”:– If you do not record your own message,the unit will play the pre-recordedgreeting-only message asking callers tocall again later.– If you use your own message, record thegreeting-only message asking callers tocall again later (page 41).Handset message indicatorYou can select whether or not the messageindicator on the handset flashes slowly whennew messages are recorded. The defaultsetting is “On”.Important:R If you stored the voicemail access number(page 47), the message indicator alsoflashes for newly recorded voicemailmessages (page 48).1 MMENUN#3402 MbN: Select the desired setting. aMSAVEN a MOFFNNote:R While message indicator is on, batteryoperating time is shortened (page 11).46 For assistance, please visit http://shop.panasonic.com/supportAnswering SystemTGE43xUS(en)_1112_ver021.pdf 46 2015/11/12 10:12:57