Panasonic KX-TGF852 Operating Instructions Manual

Also see for KX-TGF850: Operating instructions

3 Enter your remote access code within 10seconds after the long beep.R The greeting message is played back.R You can either hang up, or enter yourremote access code again and beginremote operation (page 51).Answering system settingsCall screeningHandset / Base unitWhile a caller is leaving a message, you can listento the call through the unit’s speaker.To adjust the speaker volume, press MDN or MCNrepeatedly.You can answer the call by:– lifting the corded handset from the base unit, or– pressing M N on the handset.Call screening can be set for each unit. Thedefault setting is “On”.1 MMENUN#3102 MbN: Select the desired setting. a MSAVEN3 Proceed with the operation for your unit.Handset: MOFFNBase unit: MEXITNNumber of rings before the unitanswers a callYou can change the number of times the phonerings “Ring count” before the unit answerscalls. You can select 2 to 7 rings, or “Tollsaver”.The default setting is “4 rings”.“Toll saver”: The unit’s answering systemanswers at the end of the 2nd ring when newmessages have been recorded, or at the end ofthe 5th ring when there are no new messages. Ifyou call your phone from outside to listen to newmessages (page 51), you know that there are nonew messages when the phone rings for the 3rdtime. You can then hang up without being chargedfor the call.Handset / Base unit1 MMENUN#2112 MbN: Select the desired setting. a MSAVEN3 Proceed with the operation for your unit.Handset: MOFFNBase unit: MEXITNCaller’s recording timeYou can change the maximum message recordingtime allowed for each caller. The default setting is“3 min”.Handset / Base unit1 MMENUN#3052 MbN: Select the desired setting. a MSAVEN3 Proceed with the operation for your unit.Handset: MOFFNBase unit: MEXITNSelecting “Greeting only”You can select “Greeting only” which sets theunit to announce a greeting message to callers butnot record messages.Select “Greeting only” in step 2 on “Caller’srecording time”, page 52.Note:R When you select “Greeting only”:– If you do not record your own message, theunit will play the pre-recorded greeting-onlymessage asking callers to call again later.– If you use your own message, record thegreeting-only message asking callers to callagain later (page 47).52 For assistance, please visit http://shop.panasonic.com/supportAnswering SystemTGF85x_(en)_1023_ver001.pdf 52 10/23/2019 1:26:11 PM