Viewing/editing/erasing callblock numbers1 MMENUN (right soft key) #2172 MbN: “Block a single number” or“Block range of numbers” aMSELECTN3 MbN: Select the desired entry.R To exit, press MOFFN.4 To edit a number:MEDITN a Edit the number. a MSAVENa MOFFNTo erase a number:MERASEN a MbN: “Yes” a MSELECTNa MOFFNNote:R When editing, press the desired dial key toadd, MCLEARN to erase.Erasing all call block numbers1 MMENUN (right soft key) #2172 MbN: “Block a single number” or“Block range of numbers” aMSELECTN3 MMENUN a MbN: “Erase all” aMSELECTN4 MbN: “Yes” a MSELECTN5 MbN: “Yes” a MSELECTN a MOFFNOther programmingChanging the handset nameThe default handset name is “Handset 1” to“Handset 6”. You can customize the nameof each handset (“Bob”, “Kitchen”, etc.). This isuseful when you make intercom calls betweenhandsets. To display the handset name instandby mode, turn on the handset namedisplay feature (page 42).1 MMENUN (right soft key) #1042 Enter the desired name (10 charactersmax.).3 MSAVEN a MOFFNDisplaying the handset nameYou can select whether or not the handsetname is displayed in standby mode. Thedefault setting is “Off”.1 MMENUN (right soft key) #1052 MbN: Select the desired setting. aMSAVEN a MOFFNRegistering a unitOperating additional unitsAdditional handsetsUp to 6 handsets can be registered to thebase unit.Important:R See page 4 for information on the availablemodel.Registering a handset to thebase unitThe supplied handset and base unit arepre-registered. If for some reason the handsetis not registered to the base unit, re-registerthe handset.1 Handset:MMENUN (right soft key) #1302 Base unit:Press and hold MLOCATORN for about 5seconds.R If all registered handsets start ringing,press MLOCATORN again to stop, thenrepeat this step.3 Handset:Press MOKN, then wait until a long beepsounds.Deregistering a handsetA handset can cancel its own registration tothe base unit, or other handsets registered to42 For assistance, please visit http://www.panasonic.com/helpProgramming