Error messagesDisplay message Cause/solutionAsk phonecompany forVM access #R You have not stored the voice mail access number.Store the number (page 58).Base no powerorNo link to base.Reconnect mainbase AC adaptor.orNo link.R The handset has lost communication with the baseunit. Move closer to the base unit and try again.R Unplug the base unit’s AC adaptor to reset the unit.Reconnect the adaptor and try again.R The handset’s registration may have been canceled.Re-register the handset (page 42).R When “No link.” is displayed during a powerfailure, place a handset on the base unit to supplypower to the base unit.Busy R No cellular phone is paired to the base unit. Pair acellular phone (page 16).R The called unit is in use.R Other units are in use and the system is busy. Tryagain later.R The handset you are using is too far from the baseunit. Move closer and try again.Check tel line R The supplied telephone line cord has not beenconnected yet or not connected properly. Check theconnections (page 10).R If you do not connect the telephone line cord and useonly cellular lines, set the cellular line only mode(page 18).Error!! R Recording was too short. Try again.R Someone is using a cellular line or headset. Tryagain later.R The phonebook copy is incomplete (page 47). Thecellular phone is disconnected from the base unit.Make sure that other Bluetooth devices are notconnected to the cellular phone, and try again.Failed R Although the unit tried to connect to the cellularphone or headset, the connection has been failed.– Someone is using a cellular line or headset. Tryagain later.– Make sure that the cellular phone or headset isnot connected to other Bluetooth devices.Invalid R There is no handset registered to the base unitmatching the handset number you entered.R The handset is not registered to the base unit.Register the handset (page 42).60 For assistance, please visit http://www.panasonic.com/helpUseful Information