Adjusting the ringer volumeHandsetn While the handset is ringing for anincoming call:Press MjN or MkN repeatedly to select thedesired volume.n While the handset is in standby mode:Press MjN or MkN repeatedly to select thedesired volume for landline call.R To turn the ringer off, press MkN repeatedly.Base unitn While the base unit is ringing for anincoming call:Press MjN or MkN repeatedly to select thedesired volume.n While the base unit is in standby mode:Press MjN or MkN repeatedly to select thedesired volume for landline call.R To turn the ringer off, press and hold MkNuntil the unit beeps.Note for handset and base unit:R You can adjust the ringer volume forcellular call and landline call byprogramming (page 35, 37).R The ringer volume you set is kept for eachline (landline and cellular lines).One-touch ringer off for the handsetPress and hold 0 until the unit beeps to turnthe ringer off. While the ringer is turned off, thehandset will not ring for cellular calls or forlandline calls.R You can turn the ringer on again bypressing and holding 0 until the unit beeps.Useful features during acallHold1 Press MMENUN during an outside call.2 MbN: “Hold” a MSELECTN3 To release hold on the cellular line:Press MCELLN.*1R Another handset user can take the callby pressing MCELLN.*1*1 If you press MCELLN and theselection list is displayed, selectthe desired cellular line and pressMSELECTN.To release hold on the landline:Press M /ZN.R Another handset user can take the callby pressing M /ZN.Note:R After holding for 10 minutes, the call isdisconnected.Mute1 Press MDN (Mute) during a call.2 To return to the call, press MDN (Mute).Flash for landline callsFlash button allows you to use the specialfeatures of your host PBX such as transferringan extension call, or accessing optionaltelephone services.Note:R To change the flash time, see page 39.For call waiting or Call WaitingCaller ID service usersTo use call waiting or Call Waiting Caller ID,you must first subscribe with your phoneservice provider.This feature allows you to receive calls whileyou are already talking on the phone. If youreceive a call while on the phone, you will heara call waiting tone.If you subscribe to both Caller ID and CallWaiting with Caller ID services, the 2ndcaller’s information is displayed on the unitthat is in use after you hear the call waitingtone.1 Press MACCEPTN to answer the 2nd call.2 To switch between calls, press MFLASHN.22 For assistance, please visit http://shop.panasonic.com/supportMaking/Answering CallsTGL46x(en)_1118_ver044.pdf 22 2015/11/18 9:33:30