2 MbN: Select the desired setting. aMSAVENR If you select “Off”, press MOFFN toexit.3 Enter the desired hour and minute youwish to start this feature.4 *: Select “AM” or “PM”. a MOKN5 Enter the desired hour and minute youwish to end this feature.6 *: Select “AM” or “PM”.7 MSAVEN a MOFFNChanging the start and end time1 MMENUN#2372 Continue from step 3, “Turning silentmode on/off”, page 41.Selecting groups to bypass silentmode1 MMENUN#2412 MbN: Select the desired groups. aMSELECTNR “ ” is displayed next to the selectedgroup numbers.R To cancel the selected group:MbN: Select the group. a PressMSELECTN again. “ ” disappears.3 MSAVEN a MOFFNBaby monitorThis feature allows you to listen in on a roomwhere another handset is located, allowingyou to easily monitor from different areas ofthe house or even while away from home. Themonitored handset (placed in a baby’s room,for example) will automatically call themonitoring handset or the phone numberstored when it detects sound.Important:R Before using this feature, we recommendthat you test this feature and adjust thebaby monitor sensitivity as needed,especially if you plan to monitor fromoutside.R This feature should not be used as asubstitute for a medical or caregiver’ssupervision. It is the caregiver’sresponsibility to stay close enough tohandle any eventuality.Note:R If the unit is connected to a PBX system,you cannot set the baby monitor.R During the monitoring mode, batteryconsumption is faster than usual. Werecommend leaving the monitored handseton the base unit or charger.R The monitored handset never rings while itis being monitored. If the base unit isplaced near the monitored handset, werecommend turning off the base unit ringervolume (page 35, 37).Setting the baby monitorPerform the setting operation with the handsetto be monitored (for example, the handsetplaced in a baby’s room).To monitor with a unitThe internal baby monitor feature is availablebetween handsets.1 MMENUN#2682 MbN: “On” a MSELECTN3 MbN: Select the desired unit’s number tomonitor with. a MSAVENR “Baby monitor” will be displayed.R The registered unit’s name/number isdisplayed.Note:R When this feature is on, another handsetcan hear the monitored handset by makingan intercom call.To monitor from outsideIf you enable this feature, the unit will call apre-programmed phone number when thehandset detects sound. After you answer thecall, you can listen in on the room where thehandset is located.This feature is only available for landline.42 For assistance, please visit http://shop.panasonic.com/supportProgrammingTGL46x(en)_1118_ver044.pdf 42 2015/11/18 9:33:31