Panasonic KX-UTG200 Operating Instructions Manual

Also see for KX-UTG200: Brochure & specs Getting started Administrator's guide Setup guide Administrator's guide

Contents

Panasonic KX-UTG200 Operating Instructions Manual Manual pdf 70 page image

Using a HeadsetIf a headset is connected, you must enable Headsetmode by pressing [HEADSET].Note• The Headset button light shows the currentstatus as follows:Off: Headset mode offRed: Headset mode onSetting Up the UnitThe user settings can be used to setup the unit byconfiguring the settings as required. See Page 39 forinformation about the settings.Maintaining the UnitResetting the UnitResetting all settings except for privatesettingsExecuting "Exclude Private Settings" resets all settingsexcept for private settings. Private settings includeringtone volume, brightness, phonebook, and callhistory.1. On the Home screen, select .2. Press [ ] or [ ] to select "Reset", and then press[ENTER].3. Press [ ] or [ ] to select "Exclude PrivateSettings", and then press [ENTER].4. PressYes .• To cancel, pressNo .Resetting all settings except for networksettingsExecuting "Reset Excluding Network Settings" resetsall settings except for network settings. Private settingsare reset in this case. Network settings include IPv4,IPv6, LLDP Settings, CDP Settings, VLAN Settings,Speed/Duplex, and Port Mirroring.1. On the Home screen, select .2. Press [ ] or [ ] to select "Reset", and then press[ENTER].3. Press [ ] or [ ] to select "Exclude NetworkSettings", and then press [ENTER].4. PressYes .• To cancel, pressNo .Restarting the UnitWhen some of the settings on the unit have beenchanged via Web user interface programming orconfiguration file programming, the unit must berestarted.1. On the Home screen, select .2. Press [ ] or [ ] to select "Restart", and then press[ENTER].3. PressYes .• To cancel, pressNo .70 Operating Instructions Document Version 2014-11Installation and Setup