VQT1S48112Advanced (Playback)• Depending on the photo printing store or the printer, the date may not be printed even if you setto print the date. For further information, ask at your photo printing store or refer to theoperating instructions for the printer.• The date cannot be printed on pictures stamped with text.Note• The number of prints can be set from 0 to 999.• With a printer supporting PictBridge, the date print settings of the printer may take precedenceso check if this is the case.• It may not be possible to use the DPOF print settings with other equipment. In this case, cancelall the settings, and reset the settings.• If the file is not based on the DCF standard, the DPOF print setting cannot be set.You can set protection for pictures you do not want to be deleted by mistake.Select [PROTECT] on the [PLAYBACK] mode menu. (P23)Press [‚] to return to the menu screen.• Press [MENU/SET] to close the menu.∫ Cancelling all the [PROTECT] settings1 Select [CANCEL] on the screen shown in step 2 and then press [MENU/SET].2 Press 3 to select [YES] and then press [MENU/SET].3 Press [MENU/SET] to close the menu.• If you press [MENU/SET] while cancelling protection, the cancelling will stop halfway.Note• The protect setting may not be effective on other equipment.• Even if you protect pictures in the built-in memory or a card, they will be deleted if the built-inmemory or the card is formatted.• Even if you do not protect pictures on an SD Memory Card or an SDHC Memory Card, theycannot be deleted when the card’s Write-Protect switch is set to [LOCK].P [PROTECT]Press 3/4 to select [SINGLE] or [MULTI] and thenpress [MENU/SET].Select the picture, and then press[MENU/SET].When [MULTI] has been selected• Repeat these steps for each picture.• The settings are cancelled when [MENU/SET] is pressed again.[SINGLE] [MULTI]Press 2/1 toselect the picture.Press 3/4/2/1to select thepictures.
