10Care and Cleaning of Your Microwave OvenBEFORE CLEANING:Unplug oven at wall outlet. If outlet is inacces-sible, leave oven door open while cleaning.AFTER CLEANING:Be sure to place the Roller Ring and the GlassTray in the proper position and pressStop/Reset Pad to clear the Display.Warning/Menu Label:Do not remove, wipe witha damp cloth.Oven Door:Wipe with a soft, drycloth when steamaccumulates inside oraround the outside ofthe oven door. Duringcooking, especiallyunder high humidityconditions, steam isgiven off from thefood. (Some steamwill condense on cool-er surfaces, such asthe oven door. This isnormal.)Inside surface is cov-ered with a heat andvapor barrier film. Donot remove.Glass Tray:Remove and wash in warm soapywater or in a dishwasher.Outside oven surfaces:Clean with a damp cloth.To prevent damage to theoperating parts inside theoven, water should not beallowed to seep into ventila-tion openings.Do not remove Waveguide Cover:It is important to keep coverclean in the same manner as theinside of the oven.Control Panel:• Covered with aremovable protectivefilm to preventscratches duringshipping. Small bub-bles may appearunder this film.(Hint - To removefilm, apply maskingor clear tape to anexposed corner andpull gently.)• If the Control Panelbecomes wet, cleanit with a soft, drycloth. Do not useharsh detergents orabrasives.Roller Ring and oven cavity floor:Clean the bottom surface of the ovenwith mild detergent water or windowcleaner, and dry. Roller Ring may bewashed in mild soapy water or dish-washer. These areas should be keptclean to avoid excessive noise.Inside of the oven:Wipe with a damp clothafter using. Mild detergentmay be used if needed.Do not use harsh deter-gents or abrasives.IT IS IMPORTANT TO KEEP THE OVEN CLEAN AND DRY.FOOD RESIDUE AND CONDENSATION MAY CAUSE RUSTINGOR ARCING AND DAMAGE TO THE OVEN. AFTER USE, WIPEDRY ALL SURFACES-INCLUDING VENT OPENINGS, OVENSEAMS, AND UNDER GLASS TRAY.IP2892_39R00CP_26_100310 2010.3.10 13:28 Page 12