9ª Inserting a Button-type BatteryBefore using the Remote Controller, insert the supplied button-type battery.1 While pressing the Stopper 1, pull out theBattery Holder.2 Insert the button-type battery with the imprint (i)facing upward.3 Insert the Battery Holder into the RemoteController.≥When the button-type battery is weak, replace it with a newCR2025 battery. (A battery is normally expected to last about1 year. However, it depends on operation frequency.)≥Make sure to match the poles correctly when inserting thebattery......................................................................................................CAUTIONDanger of explosion if battery is incorrectly replaced.Replace only with the same or equivalent typerecommended by the equipment manufacturer. Discardused batteries according to manufacturer’s instructions......................................................................................................WARNINGRisk of fire, explosion and burns. Do not recharge,disassemble, heat above 100xC or incinerate. Keep theButton-Type battery out of the reach of children. Never putButton-Type battery in mouth. If swallowed call your doctor......................................................................................................ª Using the Remote Controller1 Direct the Remote Controller to the RemoteControl Sensor of the Movie Camera and press anappropriate button.≥Distance from the Movie Camera: Within approximately5 metres.≥Angle: Within approximately 15o in the vertical andhorizontal directions from the central axis.≥The above operating ranges are for indoor use. Outdoors orunder strong light, the Movie Camera may not operate properlyeven within the above ranges.≥For other notes concerning this item, see page 46.1321115˚15˚15˚15˚