Panasonic NV-VP33 Series Operating Instructions Manual

Also see for NV-VP33 Series: Operating instructions Operating instructions

Contents

4 RQTV0057VHS Deck and Cassette Tape Informationª Surge AbsorberFor further protection for this product, these models are equippedwith new surge absorbing circuits which prevents damage due topower surges caused by lightning.≥This function may not be effective for surges by direct lightning.ª Crystal View ControlThe crystal view control function ensures the optimum picture qualityso that you get the best picture automatically.ª Tapes≥You can use tapes with the VHS and S-VHS marks, but this unit isunable to make full use of the characteristics of S-VHS tapes.≥Break the tape’s tab to prevent accidentalerasure. Cover the hole with a double layerof adhesive tape when you want to use thetape for recording again.ª S-VHS Quasi Playback (SQPB)It is possible to play back tapes recorded in the S-VHS system.≥Some picture noise may occur depending on the type of tape used.≥It is not possible to fully obtain the high resolution that S-VHS iscapable of.It is not possible to record in the S-VHS system with this unit.ª Dirt on the video headsIf the video heads get dirty, pictures will not be recorded or playedback clearly. (See the following conditions.)If this happens, insert and eject a cassette 5– 10 times successivelyto remove the dirt from the video heads.If the problem still persists after performing above, contact a servicepersonnel.Heads mainly become dirty because of scratched or dirty tapes, useof the unit under high temperature and humidity or under the dustand other reasons.Never use tapes on which liquids have been spilt or those that areextremely damaged since these will cause not only the heads tobecome dirty, but also the unit malfunction.ª Installing the batteriesInsert the batteries with the polarity (+ and -) correctly aligned.Notes:The service life of the batteries is approximately 1 year. However, itvaries considerably depending on the frequency of use.≥When the batteries are exhausted, remove them immediately anddispose them correctly.≥Do not mix old battery with new battery.≥Do not mix different battery types, i.e. Alkaline and Manganese.≥Do not use rechargeable batteries.≥Do not heat or short-circuit the batteries.≥When you do not use the remote control for a long time, take outthe batteries and store them in a cool, dry place.≥Operation can be affected by strong light sources, such as directsunlight, fluorescent light and the glass doors on cabinets.ª UseAim at the receiver window (l 6), avoiding obstacles, at a maximumrange of 7 m directly in front of the unit.≥Keep the transmission window and the unit’s sensor free from dust.≥Operation can be affected by strong light sources, such as directsunlight, and the glass doors on cabinets.TabHead cleaning by service agents is not covered bywarranty.Normal picture Small amount of dirt Large amount of dirtThe Remote ControlR6, AA, UM-3