Panasonic OmniVision PV-V4600 Operating Instructions Manual

Also see for Omnivision PV-V4600: User guide Service manual

Important Safeguards and PrecautionsFOR YOUR SAFETY, READ ANDRETAIN ALL SAFETY AND OPERATINGINSTRUCTIONS. HEED ALL WARNINGSIN THE MANUAL AND ON THE UNITINSTALLATION1 POWER SOURCE CAUTIONOperate only from a power source indicated on the unit or inthis manual. If necessary, have your Electric Utility ServiceCompany or Video Products Dealer verify the power sourcein your home.2 POLARIZED OR GROUNDING PLUGAs a safety feature, this Video product comes with eithera polarized power cord plug (one blade is wider than theother}, or a three-wire grounding type plug.POLARIZED PLUG CAUTION:This plug will only fit into an outlet one way. If you cannotfully insert the plug, try reversing it. If it still will not fit,have an electrician install the proper walt outlet.Do not defeat the safety feature by tampering with the plug.GROUNDING PLUG CAUTION;This plug will only fit into a three-hole grounding outlet.If necessary, have an electrician install the proper outlet.Do not defeat the safety feature by tampering with the plug.3 POWER CORDMake sure power cords are routed so that they are not likelyto have anything rest on them, roll over them, or be in theway of walking traffic. If an extension cord is used, makesure it also has either a polarized or grounded plug and thatthe cords can be securely connected. Frayed cords, damagedplugs, and damaged or cracked wire insulation are hazardousand should be replaced by a qualified service technician.Overtoaded outlets and extension cords are fire hazards andshould be avoided.4 DO NOT BLOCK VENTILATION HOLESVeniilation openings in the cabinet release heat generatedduring operation. If they are blocked, heat build-up inside theunit can cause faitures that may resutt in a fire hazard orheat damage to cassettes.For protection, follow these rules:a. Never cover ventilation slots or the unitwhile in use, or operate the unit when placedon a bed, sofa, rug, or other soft surface.b. Avoid built-in installation, such as a book caseor rack, unless proper ventilation is provided.5 AVOID EXTREMELY HOT LOCATIONS ORSUDDEN TEMPERATURE CHANGESDo not place the unit over or near any kind of heateror regulator, in direct sunlight, inside a closed vehicle, etc..Do not move the unit suddenly between areas of extremetemperature variation. if the unit is suddenly moved from acold place to a warm place, moisture may condense in theunit and on the tape.6 TO AVOID PERSONAL INJURY+ Do not place unsecured equipment on a sloping surface.* Do not place this unit on any supponthat is not firm, level, and adequatelystrong. The unit could fall causingserious injury to a chitd or adult anddamage to the unit.An appliance and cart combinationshould be moved with care,Quick stops, excessive force, anduneven surfaces may cause theappliance and cart combination to overturn.Carefully follow all operating instructions and usethe manufacturers recommended accessories whenoperating this unit or connecting it to any other equipment.eSafety Precautions1OUTDOOR ANTENNA INSTALLATIONSAFE ANTENNA AND CABLE CONNECTIONIf an outside antenna or cable systemis connected to the equipment,be sure the antenna or cable systemis grounded so as to provide somaprotection against built up staticcharges and voltage surges.Section 810 of the NationalElectrical Code, ANSI/NFPA 70(in Canada, part 1 of the Canadian pe MEC RECTION 10-31)Electrical Code) provides information Al ¿En CAD CAMwith respect to proper grounding of the ‘mast and supporting structure, groundingof the lead-in wire to an antenna discharge unit,size of grounding conductors, location of antenna discharge unit, connectionto grounding electrodes and requirements for the grounding electrode.KEEP ANTENNA CLEAR OF HIGH VOLTAGE POWER LINESOR CIRCUITSAn outside antenna system should be located well away from power lines,electric light or power circuits and where it will never come into contact withthese power sources if it should happen to fall. When installing an outsideantenna, extreme care should be taken to avoid touching power lines,circuits or other power sources as this could be fatal. Because of thehazards involved, antenna installation shoutd be left to a professional.USING THE VIDEO UNITNEC -~ NATIONALELECTRICALIf the unit has been in storage or moved to a new location,refer first to the INSTALLATION section of these safeguards.121KEEP THIS VIDEO UNIT AWAY FROM WATER ORMOISTURE OF ANY KIND.IF EQUIPMENT IS EXPOSED TO RAIN, MOISTURE, ORSTRONG IMPACT, unplug the unit and have it inspected by a qualifiedservice technician before use.DURING AN ELECTRICAL STORMDuring a lightning storm, whether indoors or outdoors, or before leaving theunit unused for extended periods of time, disconnect all equipment from thepower source as well as the antenna and cable system.WHEN THE UNIT IS PLUGGED IN« Never expose the unit to rain or water. DO NOT OPERATEif liquid has been spilled into the unit. Immediately unplug the unit,and have it inspected by a service technician. Fire and shock hazardscan result from electrical shorts caused by liquid contact inside.* Never drop or push any object through openings in the unit. Some intemal partscarry hazardous voltages and contact can cause electric shock or fire hazard.* Avoid placing the unit directly above or below your TV set as this may causeelectrical interference. Keep all magnets away from electronic equipment.USING ACCESSORIESUse only accessories recommended by the manufacturer to avoid risk of fire,shock, or other hazards.CLEANING THE UNITUnplug the unit. Then, use a clean, dry, chemically untreated cloth to gentlyremove dust or debris. DO NOT USE cleaning ituids, aerosols, or forced airthat could over-spray, or seep into the unit and cause electrical shock.Any substance such as wax, adhesive tape, etc. may mar the cabinet surface.Exposuré to greasy, humid, or dusty areas may adversely affect intemal parts.SERVICEDO NOT SERVICE THIS PRODUCT YOURSELFIf, after carefully following the detailed operating instructions, this Videoproduct does not operate properly, do not attempt to open or removecovers, or make any adjustments not described in the manual.Unplug the unit and contact a qualified service technician.IF REPLACEMENT PARTS ARE REQUIREDMake sure the service technician uses only parts specified by the manufacturer,or those having the same safety charactenstics as the original parts. The use ofunauthorized substitutes may result in fire, electric shock, or other hazards.3 HAVE THE SERVICE TECHNICIAN PERFORM A SAFETY CHECKAfter any service or repairs to the unit, request the service technician toconduct a through safety check as described in the manufacture’s serviceliterature to insure that the video unit is in safe operating condition.Warning: To prevent fire or shock hazard, do not expose this equipment to rain or moisture.CAUTION: To prevent electric shock, match wide blade of plug to wide slot, fully insert.Attention: Pour éviter les chocs électriques, introduire la lameondante de la prise et pousser jusqu’au fond.This symbol wams the user that uninsulated voltage within the unit may have sufficient magnitude to causeelectric shock. Therefore, it is dangerous to make any kind of contact with any inside part of this unit.borne correspCAUTIONA ADO NOT OPENCAUTION TO REDUCE THEPISK OFELECTRIC BHOCK,DO NOTREMOVE COVER (ORBACK}MOUSER-BERVICEMELEPAATS INSIDEREFER BERVICING TO QUALIFIED SERVICE PERSONNELa plus large de la fiche dans laThis symbol alerts the user that important literature conceming the operation and maintenance of this unithas been included. Therefore, it should be read carefully in order to avoid any problems.For assistance, call 1-800-211-PANA(7262).