Panasonic OmniVision PV-V4600 Operating Instructions Manual

Also see for Omnivision PV-V4600: User guide Service manual

Before Requesting ServiceCheck the following points once again if you are having trouble with your VCR.Power CorrectionNo power... + Completely insert Power Plug into an AC outlet.» Set POWER button to on.* Make sure power source is active.Recording & Playback CorrectionTV program cannot be recorded... Check connections between VCR, external antenna, and TV.Check hook up selection. (P.4-5)Make sure your antenna system (CABLE or TV) is correctly set.(Channels [P.32))Make sure cassette record tab is intact. (P.34)Timer recording cannot be performed... Check clock is set to current time and date.Make sure Cable/DSS box (if used) is left on and tuned tochannel to be recorded.Set recording start/stop times correctly. (P.12)Make sure POWER button is set to off. (P.12, 13)Timer recording may not be performed or continued if a powerinterruption of more than 1 minute occurs before or during, aTimer Recording, even after power is restored.There is no playback picture, or the playback Select channel 3 or 4 on TV to match VCR output channel (3 or 4)picture is noisy or contains streaks... (P.6) or select LINE.Set VCR/TV selector to “VCR.”Adjust TRACKING control in either direction. (P.35)Try Head Cleaning. (P.35)Special effects playback, picture may contain Set TV's Vertical Hold Contro! to MANUAL, then adjust.some vertical jitter when using a TV with anAutomatic Vertical Hold Control...VCR cannot be controlled... Make sure VCR LOCK is set to off. (P.30)Make sure remote is in proper mode. (P.18)Make sure unit is not in a Timer Record operation.Remote Control CorrectionVCR cannot be remote controlled... Aim Remote Control directly at remote sensor on VCR. (P.42)Avoid any object blocking signal path.Check remote batteries. (P.4)Make sure VCR LOCK is set to off. (P.30)Exposing VCR remote sensor to direct fluorescent or outdoorlight may cause signal interference.ACTION and PROG/VCR+ buttons cannot be * Press VCR button for VCR mode. (P.18)used... + Check remote Batteries. (P.4)Miscellaneous CorrectionPrograms cannot be viewed on TV... + Set VCR/TV selector to “TV.” (P.9)e Make sure proper signal source is selected.Video cassette cannot be inserted... * Insert the cassette with window side up; record tab facing you.* Insure no other tape is inside unit.Video cassette cannot be removed... e Completely insert Power Plug into AC outlet.Video cassette ejects when a recording is started] * Make sure cassette record tab is intact. (P.34)or the power is turned off for timer recording...In Stop mode, the motor (CYLINDER) continues | + To enable Quick play mechanism, the cylinder will rotate forto rotate... about 5 minutes. This reduces response time from Stop to Playmode and from Play to Rewind Search mode.The top of the playback picture waves back and Because VCR playback signal is not as stable as off-the-air TVforth excessively... signal, top of TV screen may be bent or unstable duringplayback. Slowly turn TV horizontal Hold control to correct. Ifyour TV has no horizontal Hold control or adjusting control isineffective, contact your nearest TV service center.If you cannot resolve the problem, please call the Customer Satisfaction Center forproduct assistance at 201-348-9090.To locate an authorized servicenter, please call toll free 1-800-211-PANA (7262). 39/41BunsaaojagYGSO