Panasonic PAW-HPM 1 User Manual

61.2 Model overview and AccessoriesThe product range of the PAW-HPM consists of the HPM controller (with or withoutdisplay), the adapter cable (enabling communication with a split- or mono-block heatpump) and miscellaneous sensors:Controller type Display and Keys BUS * WebPAW-HPM1 X X XPAW-HPM2 X X* Communication with a heat pump requires additional adapter cable of model INT-XTable 1.1: Controller typesThe HPM1 is a standardized controller for systems including a heat pump. Control ofthe heat pump can take place either via a contact or via communication. A HPMcontroller can be used for cascade control of up to 3 heat pumps. For demand viacontact, only one HPM1 is required. When utilising cascade control via acommunication port, one HPM1 is required as a master controller and up to 2 HPM2as slave controllers (for communication with heat pumps 2 and 3). In addition, theHPM controllers must be connected via an Ethernet port.Accessories Description UsageAdapter cable:PAW-HPMINT-U Adapter cable, HPM-split HP, 5V,3mCommunication with a split-heatpumpPAW-HPMINT-M Adapter cable, HPM-mono-blockHP, 12V, 30mCommunication with a MONO-block-heat pumpSensors:PAW-HPMUH Outdoor sensor, -30…+70°C For weather-dependant setpointcalculationPAW-HPMAH1 Clamp-on sensor, -20…+120°C Flow temperature for the heatingcircuitPAW-HPMB1 Universal cable temperature sensor,-30…+100°C Domestic hot water, buffer tankPAW-HPMSOL1 Cable temperature sensor,-50 - +250°CSolar collector, domestic hotwater, buffer tank (high temp.)PAW-HPMDHWImmersion temperature sensor,-20 - +120°C, with pocket, R1/2",L=90mm, stainless steelFlow temperatur for heatingcircuit, domestic hot water,buffer tankPAW-HPMR4 Room temperature sensor withsetpoint adjustment, 5 – 30°CRoom temperature and remotesetpoint potentiometer forheating circuitTable 1.2: Accessories1.3 The HPM-PackageThe HPM Package consists of the following componentsx Controllerx Socketx Installation instruction