Panasonic PT-43LC14-K Operating Instructions Manual

Contents

35Basic OperationVCRDVD playerThis equipment canalso be connected tothe rear terminals. SeeConnections for details.Turning the power on and switching input modesTurn the projectiondisplay on.12 The input mode changeseach time this button ispressed.* If SKIP is set as the InputLabel setting of SETUP,the mode will not bechanged. (P. 55)3 Operate the connected equipment.Confirming connectionsA video camera uses the Input 3 terminal on the front of the projection display.Video cameraTo S-video outputor video outputTo audio outputExample: Connect Input 3VIDEO 1 Signal of source connected to INPUT 1 is displayed.VIDEO 2 Signal of source connected to INPUT 2 is displayed.VIDEO 3 Signal of source connected to INPUT 3 is displayed.COMPONENT 1 Signal of source connected to COMPONENT VIDEO INPUT 1 is displayed.COMPONENT 2 Signal of source connected to COMPONENT VIDEO INPUT 2 is displayed.COMPONENT 3 Signal of source connected to COMPONENT VIDEO INPUT 3 is displayed.COMPONENT 4 Signal of source connected to COMPONENT VIDEO INPUT 4 is displayed.RGB 1 (orRGB)Signal of source connected to RGB IN 1 (or RGB IN) isdisplayed.RGB 2 Signal of source connected to RGB IN 2 is displayed.HDMI Signal of source connected to HDMI IN is displayed.CARD Signal of source connected to CARD SLOT is displayed.TVVIDEO 1 *VIDEO 2 *VIDEO 3 *COMPONENT 1 *COMPONENT 2 *HDMI*COMPONENT 4 *COMPONENT 3 *Card input mode isselected.Playing peripheral equipmentRGB 2*(For PT-50LC14-K/ PT-60LC14-K)RGB 1*(For PT-50LC14-K/ PT-60LC14-K)RGB*(For PT-43LC14-K)Remote ControlUnitPOWERSAPLIGHTMENU1 2 34 5 67 809EXITCHCHVOL VOLR-TUNESWAPREWFREEZETV/VCRSPLIT CHDVD/VCR CH SEARCHOPEN/CLOSESPLITPLAYPAUSE STOP RECSPLIT CTRLFFPROGTV/VIDEO A - ANTENNA - BTV VCR DVDDTV RCVR DBS/CBL AUXOKMUTEASPECTBBERECALL• Pressing SD again exitsCard input mode.