Panasonic PT-D4000U Operating Instructions Manual

Also see for PT-D4000U Series: Setup and operation manual Operating instructions Limited warranty Brochure & specs

Contents

Panasonic PT-D4000U Operating Instructions Manual Manual pdf 32 page image

32How to erase sub memorySelect sub memory number (1 to 8) correspondingto sub memory to be erased using buttons.Press the DEFAULT button.Read the confirmation message and select.How to select sub memorySelect sub memory number (1 to 8) using thebuttons. Select “–” if you do not wish touse the sub memory.Press the ENTER button.• You cannot select sub memory of adifferent signal system.NoteRegistering in sub memorySelect the sub memory number to be registeredusing the buttons.Press the ENTER button.• Sub memories range from 1 to 8.NoteCOLOR CORRECTIONOFF : This is the standard setting.USER : The six colors of red, green, blue, cyan,magenta and yellow can be adjustedand registered for each of four signalsystems: Video, S-Video, RGB andYPB PR .Press the ENTER button to make thedetailed settings.RETURNSTORESUB MEMORY LIST- : RGB1-XGA601: RGB1-XGA602: VIDEO-NTSC3:4:5:6:7:8:SELECTCONTRAST MODEThere are two modes for adjusting to the operatingenvironment.NORMAL : The brightness is set to maximum.HIGH : The contrast is set to maximum.AUTO SIGNALThe position where the screen is displayed can beadjusted automatically without pressing the AUTOSETUP button on the remote control each timesignals are input when signals are input frequentlysuch as when the projector is used at a conference.ON : Auto setup is performed automaticallywhen the video signals of the imagesbeing projected have changed.OFF : The input auto setup function is set toOFF.BACK COLORYou can set the colors of the screen when no signalis input to the projector.BLUE : Set screen color to blue.BLACK : Set screen color to black.LOGO1 : The picture registered by the user willbe projected.LOGO2 : The Panasonic logo is projected.STARTUP LOGOThis sets the startup logo that is projected when thepower is turned on.LOGO2 : This is the standard setting. ThePanasonic logo is projected.NONE : “STARTUP LOGO” is disabled.LOGO1 : The picture registered by the user willbe projected.SUB MEMORY LISTMultiple sets of image adjustment data (PICTURE,POSITION, ADVANCED MENU adjustment values)for the same kind of signal can be registered.COLOR CORRECTIONRRGBGBCyMgYeADJUSTMENU SELECT000000The current signal system is displayed.• Separate software is required in orderto create the pictures to use for“LOGO1”. Consult your dealer.NoteOPTION1 settingsOPTION1COLOR CORRECTIONCONTRAST MODEAUTO SIGNALBACK COLORSTARTUP LOGOSUB MEMORY LISTDVI EDIDCHANGEMENU SELECTUSERNORMALOFFBLUEOFFEDID2:PCDVI SIGNAL LEVEL 0-255:PCFUNC1OSD POSITION 1OSD MEMORY ON