11AC IN terminal (page 24)Connect the supplied line power cord into thisreceptacle.Do not connect any other cable to this socket.Air filter (page 55)Burglar lockAttach a commercial burglar prevention cable (e.g.,from Kensington) to this lock port. It is compatiblewith the Microsaver Security System fromKensington.Clasp for attaching anti-theft chainAttach a chain or other fastening device availablefrom a hardware store through this clamp.Level-adjusting feet (page 24)Use these feet to adjust the tilt of the projector.(The leveling feet at the front left and right can beadjusted.)Lens release button (page 26)Press this to remove the projection lens.Projection lensLens for projecting images on the screen.Lens left/right adjusting dial (page 27)Turn this clockwise to move the screen to the left;conversely, turn it counterclockwise to move it tothe right.Remote control receiver window (front) (page 14)This window receives the signal beam emitted fromthe remote control.Focus ring (page 26)For focus adjustment.Powered focus adjustment is also available.Temperature monitor (TEMP) (page 54)Lighting or blinking of this lamp indicates anabnormal condition of the internal temperature.LAMP1 monitor (page 54)This lamp lights up when the time to replace lampunit 1 is reached. It also blinks if somethingunusual occurs in the lamp circuit.LAMP2 monitor (page 54)This lamp lights up when the time to replace lampunit 2 is reached. It also blinks if somethingunusual occurs in the lamp circuit.Power indicator (page 24)The lamp lights in red when the MAIN POWERswitch is turned to “l” (on). It turns to green whenthe POWER ON button of the remote control or themain unit is pressed.Lens capCap the lens whenever the projector is left unused.Air intake ventsSide-mountedconnection terminals(page 13)Status LED lights(Refer to the figureon the right.)Front and side of the projectorStatus LED lights• Do not remove the upper cover (white orblack top panel).Attention