Panasonic PT DW5100UL Operating Instructions Manual

Contents

Panasonic PT DW5100UL Operating Instructions Manual Manual pdf 26 page image

26How to adjust the lensHow to install and removethe projection lensHow to install theprojection lensAlign the guide of the projection lenswith the guide groove in the main unit.Turn the lens clockwise until it clicksinto place.How to remove theprojection lensTurn the lens counterclockwise asfar as it will go.While holding down the lens releasebutton, turn the lens furthercounterclockwise.Remove the lens.Note • Before replacing the lens, turn off theprojector’s power.• Do not touch the lens signal contact.Dust or dirt may cause defectivecontact.• Do not touch the surface of theprojection lens with your bare hands.• Store the replaced lens where it willbe free from vibration and impact.Lens release buttonGuide grooveGuide grooveGuideGuide Projection lensLens signal contact• Turn the lens counterclockwise andconfirm that the lens does not comeoff.AttentionHow to adjust the FOCUS,ZOOM and SHIFTThe focus, zoom and up/down position of theimages projected on the screen can be adjustedwhile the projector is positioned appropriately inrelation to the screen.At the projectorPress LENS on the control panel onthe main unit.Pressing the button changes the setup screenin the order of “FOCUS”, “ZOOM” and “SHIFT”.Press to select an itemand adjust it.Using the remote controlPress LENS (FOCUS/ZOOM/SHIFT)on the remote control.When the FOCUS button is pressed :The focus is adjusted.When the ZOOM button is pressed :The zoom is adjusted.When the SHIFT button is pressed :The shift is adjusted.Press to select an itemand adjust it.CautionBe careful not to catch your fingers between thelens and shroud when shifting the lens.• When a lens without zoom functionsis used, the lens zoom adjustmentmenu will still displayed, but nooperations can be performed usingthe items on this menu.• By shifting the lens up/down position,it is possible to make adjustmentsupward or downward from thestandard position in the direction ofthe upper 50 % of the projectedscreen height. However, when usingET-DLE050 lens, the shift adjustmentis not possible.• Operations can be performed fasterby holding down the buttonsfor about 3 or more seconds.• Do not adjust the lens focus in theinitial period (within 30 minutes) afterswitching on.• A warm-up period of at least 30 minutesis recommended before using theprojector.Note