Chapter 4 Settings — [PROJECTOR SETUP] menuENGLISH - 119[SCHEDULE]Set the command execution schedule for each day of the week.Enabling/disabling the schedule function1) Press as to select [SCHEDULE].2) Press qw to switch the item.f The items will switch each time you press the button.[OFF] Disables the schedule function.[ON] Enables the schedule function. Refer to “How to assign a program” (x page 119) or “How to set aprogram” (x page 119) for how to set the schedule.Notef When [SCHEDULE] is set to [ON], the [STANDBY MODE] setting is forcibly switched to [NORMAL], and the setting cannot be changed.Even if [SCHEDULE] is then set to [OFF] when in this state, the setting of [STANDBY MODE] remains at [NORMAL].How to assign a program1) Press as to select [SCHEDULE].2) Press qw to select [ON], and press the button.f The [SCHEDULE] screen is displayed.3) Select and assign program to each day of week.f Press as to select the day of week, and press qw to select a program number.f You can set the program from No.1 to No.7. “- - -” indicates that the program number has not been set.How to set a programSet up to 16 commands to each program.1) Press as to select [SCHEDULE].2) Press qw to select [ON], and press the button.f The [SCHEDULE] screen is displayed.3) Press as to select [PROGRAM EDIT].4) Press qw to select a program number, and press the button.5) Press as to select a command number, and press the button.f You can change the page using qw.6) Press asqw to select [TIME], and press the button.f The projector is in the adjustment mode (where the time is blinking).7) Press qw to select “hour” or “minute”, and press as or the number (<0> - <9>) buttons to set atime, and then press the button.8) Press asqw to select [COMMAND].9) Press the button.f The [COMMAND] detailed screen is displayed.10) Press as to select a [COMMAND].f For [COMMAND] which requires detailed settings, the items of the detailed settings will switch each timeyou press qw.f When [INPUT] is selected, press the button, and then press asqw to select the input to beset.
