Chapter 3 Basic Operations — Operating with the remote controlENGLISH - 67Switching the inputThe input for projection can be switched.button1) Press the input selection (, , , f This operation can be also performed using the buttons on the control panel. Switches the input to RGB1 or RGB2. Switches to the other input when one input has already beenchosen. Switches the input to DIGITAL LINK. Switches the input to DVI-D.*1 Switches the input to RGB1.*2 Switches the input to SDI. Switches the input to HDMI.*1 The operation is disabled in the factory default settings. The operation is enabled when [REMOTE CONTROL] is set to [USER] and [VIDEOBUTTON] of [INPUT SELECT BUTTON] is set to other than [DISABLE], from the [SECURITY] menu → [CONTROL DEVICE SETUP].*2 SDI input is supported only for PT-DZ780.Notef When the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G) is connected to the LAN> terminal, the input on the DIGITAL LINK output supported device changes each time the button is pressed. The inputcan also be changed using the RS-232C control command.For twisted-pair-cable transmitters of other manufacturers, switch the input on the projector to DIGITAL LINK, and then switch the input onthe twisted-pair-cable transmitter.Using the Status functionYou can display the status of the projector.button1) Press the button.f The [STATUS] screen is displayed.88h70h/ ON/70h/ ON/1/51.00 / 1.0026°C/78°F32°C/89°F42°C/107°F1013hPaMENU EXITCHANGEENTER SEND E-MAILSELF TESTATMOSPHERIC PRESSUREAUTO - FLOORNO ERRORSCOOLING CONDITIONEXHAUST AIR TEMP.OPTICS MODULE TEMP.INTAKE AIR TEMP.MAIN/SUB VERSIONLAMP1PROJECTOR RUNTIMEPROJECTOR TYPE DZ780(123456789012)STATUSLAMP2Notef This can be displayed from the [PROJECTOR SETUP] menu → [STATUS] (x page 122).
