[3D SETTINGS] menu (PT-DZ21KU and PT-DS20KU only)ENGLISH - 87 Settings[3D INPUT FORMAT]Set the 3D format for the image signals being input.Set a 3D format that matches the input signal.1) Press ▲▼ to select [3D INPUTFORMAT].2) Press the button.▶z The [3D INPUT FORMAT] screen is displayed.3) Press ▲▼ to select a 3D format.4) Press the button.[AUTO]*1Automatically detects 3D format ofinput image signals and displaysimages.[NATIVE] Forcibly displays images in 2Dregardless of input image signals.[SIMULTANEOUS]*2Forcibly displays 3D images insimultaneous format regardless ofinput image signals.[SIDE BYSIDE]Forcibly displays 3D images in sideby side format regardless of inputimage signals.[TOP ANDBOTTOM]Forcibly displays 3D images in topand bottom format regardless ofinput image signals.[LINE BYLINE] *3Forcibly displays 3D images in lineby line format regardless of inputimage signals.[FRAMESEQUENTIAL]*4Forcibly displays 3D images in framesequential format regardless of inputimage signals.*1: During DVI-D or HDMI input only*2: During 3G-SDI level B input only*3: During signals other than interlaced signals are input*4: During RGB1, RGB2, DVI-D, and HDMI input onlyNotez When set to [AUTO], [SIMULTANEOUS], [SIDE BYSIDE], [TOP AND BOTTOM], [LINE BY LINE], or[FRAME SEQUENTIAL], images are not displayedin 3D as per the [3D SIMUL INPUT SETTING].However, this only occurs in [AUTO] when 3Dformat can be recognized.z This may not function properly for some externaldevices that are connected.[LEFT/RIGHT SWAP]Flips the timing of the switch between the left andright of an image to display. Change the setting if the3D images you see appear strange.1) Press ▲▼ to select [LEFT/RIGHTSWAP].2) Press ◀▶ to switch [LEFT/RIGHTSWAP].▶z The setting will change as follows each timeyou press the button.[NORMAL] [SWAPPED][NORMAL]If the 3D images are displayedcorrectly, do not change the[NORMAL] settings.[SWAPPED]Select when left and right 3Dimages are swapped to bedisplayed.Notez This is disabled when [3D SYSTEM SETTING] isset to any setting other than [SINGLE].[3D COLOR MATCHING]Switches the color matching correction data applied tothe displayed image.1) Press ▲▼ to select [3D COLORMATCHING].2) Press ◀▶ to switch [3D COLORMATCHING].▶z The setting will change as follows each timeyou press the button.[SHARED 2D/3D] [SEPARATE 2D/3D][SHARED2D/3D]2D signals and 3D signals use thesame correction data.[SEPARATE2D/3D]2D signals and 3D signals usedifferent correction data.Notez Keep the signal you want to adjust input when youswitch the [COLOR MATCHING] ( page 91) setting.
