Panasonic PT-F100NT Network Manual

Also see for PT-F100NT: Specifications Dimensions Network Operation Manual Setup and operation manual Spec file

Contents

Panasonic PT-F100NT Network Manual Manual pdf 60 page image

60Your current settings appear.Select [STATUS] at the network menu and press the [ENTER] button.Verifying settingsNetwork/Security setting of the projector (cont.)You can reset the network setting to the factory default of the projector.Select [INITIALIZE] at the network menu and press the [ENTER] button.1Select [OK] with the [ ] buttons and press the [ENTER]button.2Returning to the initial settingsThe entry of the password is prompted if [Password setting] is turned [ON] in the “ Security” menu.The status of the following will appear.WIRED LAN WIRELESS LANDHCP “ON” - “OFF” ANTENNA LEVEL (The strength of the connection will appear.)IP ADDRESS (See page 53) NETWORK “S-MAP”, “1” - “4”, “USER1” - “USER3”SUBNETMASK (See page 53) MODE “AD-HOC” - “INFRASTRUCTURE”DEFAULT GATEWAY (See page 53) CHANNEL Refer to page 5 for usable channels.MAC ADDRESS SSID (See page 55)AUTHENTICATION “OPEN” - “SHARED”-“WPA-PSK”-“WPA2-PSK”DEFAULT KEY “-” - “1” - “4”ENCRYPTION “NONE” - “WEP” - “TKIP” - “AES”DHCP “ON” - “OFF”IP ADDRESS (See pages 54, 56)SUBNETMASK (See pages 54, 56)DEFAULT GATEWAY (See pages 54, 56)MAC ADDRESSRETURNENTERSELECTLANGUAGEPROJECTOR SETUPSECURITYPOSITIONDISPLAY OPTIONWIRED LANNAME CHANGECOMPUTER SEARCHMULTI-LIVESTATUSINITIALIZEPICTURENETWORKS-MAPWIRELESS LANPASSWORD OFFPASSWORD CHANGEOFFNETWORK STANDBYNETWORK CONTROL ONLIVE MODE CUT IN OFFRETURNENTERSELECTLANGUAGEPROJECTOR SETUPSECURITYPOSITIONDISPLAY OPTIONWIRED LANNAME CHANGECOMPUTER SEARCHMULTI-LIVESTATUSINITIALIZEPICTURENETWORKS-MAPWIRELESS LANPASSWORD OFFPASSWORD CHANGEOFFNETWORK STANDBYNETWORK CONTROL ONLIVE MODE CUT IN OFFINITIALIZERETURNENTERSELECTINITIALIZEOK CANCEL