Panasonic PT-LC56E Operating Instructions Manual

Panasonic PT-LC56E Operating Instructions Manual Manual pdf 14 page image

AUTO RGB INENGLISH -27 Useful functions26-ENGLISHCorrecting keystone distortion andautomatic positioning (AUTO SET UP)This projector detects its degree of tilt and the input signal. Keystone distortion and theposition of the image can then be corrected automatically in accordance with the input signal.Turning off the picture and soundmomentarily (SHUTTER)The shutter function can be used to momentarily turn off the picture andsound from the projector when the projector is not being used for shortperiods of time, such as during breaks in meetings or when carrying outpreparation. The projector uses less power in shutter mode than it does innormal projection mode.ENTERFREEZE SHUTTERINDEXWINDOWPROJECTORVOLUME D.ZOOMSTDVIDEOINPUTPOWERRGBMENUAUTOSETUPENTERFREEZEINDEXWINDOWPROJECTORVOLUME D.ZOOMSTDVIDEOINPUTPOWERRGBMENUAUTOSETUPSHUTTERENTERINDEXWINDOWPROJECTORVOLUME D.ZOOMSTDVIDEOINPUTPOWERRGBMENUAUTOSETUPSHUTTERFREEZEProjector control panelPress the AUTO SETUP button.(When the projected image has caused keystone distortion)B Automatic positioningwill be carried out.Still pictureScreenProjectedimageIf you press the AUTO SETUP button, the items given in the table below willbe set automatically in addition to keystone distortion being corrected. Thesetting details change according to the signal which is being input.B The picture being projected will be paused.B Press the FREEZE button again to cancel thestill picture.[NOTE:B If the edges of the projected picture are indistinct, or if a dark picture is beingprojected, the automatic setup processing may stop automatically before it iscomplete. If this happens, project a different picture and then press the AUTOSETUP button once more, or make the above adjustments manually.B If you would like to make further adjustments to the picture, use the menucommands which are listed on page 30 and subsequent pages.B Set “AUTO KEYSTN” in the OPTION1 menu to “OFF” to prevent any deteriorationof the picture as a result of keystone correction. (Refer to page 42.)Press the SHUTTER button.B The picture and sound will be turned off.B Press any button on either the projector orremote control unit to return to normal operatingmode.Press the FREEZE button.NOTE:B “SHUTTER” on the MAIN MENU is the samefunction.Pausing a picture (FREEZE)Input signal Contents set up automaticallyPOSITION, DOT CLOCK, CLOCK PHASE(If the dot clock frequency is 100 MHz or higher, the DOTCLOCK and CLOCK PHASE will not be set automatically.)AUTO RGB INRGB signalsYPBPR signalsPage384242