Basic OperationSwitching the projector on/offENGLISH - 20J By control panel operationMake sure the CONTROL PANEL setting inOPTION menu is set to VALID.1. Press the POWER button.The confirmation screen will be displayed.Without any operation for 10 seconds or press anybutton other than the POWER button, theconfirmation screen will go off and return to theprojection.2. Press the POWER button again in 10 seconds.3. The POWER indicator will flash in orange.The projector is cooling the lamp.4. The POWER and POWER LOCK indicator switchto red.J By remote control operation1. Press the POWER button.The confirmation screen will be displayed.Without any operation for 10 seconds or press anybutton other than the POWER button, theconfirmation screen will go off and return to theprojection.2. Press the POWER button again in 10 seconds.3. The POWER indicator will flash in orange.The projector is cooling the lamp.4. The POWER and POWER LOCK indicator lightred.J By direct power off functionYou can switch off the projector by disconnectingthe power cord. See “Direct power off function” onpage 18.Switching off the projectorFUNCTIONMENU RETURNINPUT SELECTRELEASERELEASE4(3 - 4)(4)(1 - 2)NOTE:• You can switch off the power without displaying the confirmation screen by pressing the POWER button for longer than0.5 second.• When the internal cooling fan is operating, some, operational sound may be heard. The loudness of the operational sounddepends on the external temperature.• If the projector is switched on again while the internal cooling fan is still operating by the internal power supply, it may takea while to start the projection.• Operating the control panel buttons with covered hand, such as plastered or gloved hand, may result in fail.