Panasonic PT-P1SDU Operating Instructions Manual

Contents

E NGLISH -6362-ENGLISHSpecificationsPower supply: 100 V - 240 V ~, 50 Hz/60 HzPower consumption: 180 W [During standby (when fan isstopped): Approx. 3 W]Amps: 2.2 A - 1.0 ALCD panel:Panel size (diagonal): 0.6 type (15.24 mm)Aspect ratio: 4:3Micro lens array: AvailableDisplay method: 3 transparent LCD panels (RGB)Drive method: Active matrix methodPixels: 480 000 (800 x 600) x 3 panelsLens: Manual zoom (1.2 x) / Manual focusF 1.7 - 1.8 f 17.0 mm - 20.4 mmLamp: UHM lamp (130 W)Luminosity: 1 500 lmScanning frequency (for RGB signals):Horizontal scanning frequency: 15 kHz - 91 kHzVertical scanning frequency: 50 Hz - 85 HzDot clock frequency: Less than 100 MHzYPBPR signals: 480i, 576i, 480p, 576p, 1 080/60i,1 080/50i, 720/60pColor system: 7 (NTSC/NTSC 4.43/PAL/PAL-M/PAL-N/PAL60/SECAM)Projection size: 965 mm - 7 620 mm (38˝ - 300˝)Throw distance: 1.2 m - 9.9 m (3´11˝ - 32´5˝)Optical axis shift: 4:1 (fixed)Screen aspect ratio: 4:3Installation: Front/Rear/Ceiling/Desk (menu selection)Speaker: 2.0 cm round x 1Max. usable volume output: 0.5 W (mono)ConnectorsPC IN: Single-line, D-sub HD 15-pin (female)During RGB input:R.G.B.: 0.7 V [p-p], 75 ΩG.SYNC: 1.0 V [p-p], 75 ΩHD/SYNC: TTL, automatic positive/negative polaritycompatibleVD: TTL, automatic positive/negative polaritycompatibleDuring YPBPR input:Y: 1.0 V [p-p] (Including sync), 75 ΩP B, PR : 0.7 V [p-p], 75 ΩOthersRemovingRemoving and attaching the lens coverB Turn the ring to the right and remove thelens cover.AttachingB Replace the lens cover and turn it to theleft to lock it in place.Before carrying out cleaning and maintenance, besure to disconnect the power cord plug from thewall outlet.Wipe the cabinet with a soft, dry cloth.If the cabinet is particularly dirty, soak the cloth in water with a small amountof neutral detergent in it, squeeze the cloth very well, and then wipe thecabinet. After cleaning, wipe the cabinet dry with a dry cloth. If using achemically-treated cloth, read the instructions supplied with the cloth beforeuse.Do not wipe the lens or the lens cover with a cloth that is dusty orwhich produces lint.If any dust or lint gets onto the lens or the lens cover, such dust or lint will bemagnified and projected onto the screen. Use a blower to clean any dust andlint from the lens and the lens cover surface, or use a soft cloth to wipe offany dust or lint.Cleaning and maintenanceNOTE:B The lens cover is made of glass, so dropping it or allowing it to hit hardobjects may cause it to break. Be careful when handling the lens coverB Use the projector with the lens cover attached.