5) Press as to select the item to adjust, then press the button.f The [CURVED CORRECTION] individual adjustment screen is displayed.6) Press as to select one item to adjust.[LENS THROW RATIO]*1 Adjusts when the throw ratio of projector lens is changed.[KEYSTONE] *2 Adjusts when the trapezoid of the projected image is distorted.[ARC] *3 Adjusts when the radian of the projected image is distorted.[BALANCE] *4 Adjusts when the balance of the projected image is distorted.[MAINTAIN ASPECT RATIO] Set to [ON], maintain the aspect ratio when correct the curved distortion of theprojected image.*1 The adjustment values are [0.9] to [2.3].For details, please refer to [KEYSTONE] → [LENS THROW RATIO]. (Æ page 65)*2 For details, please refer to [KEYSTONE] → [KEYSTONE]. (Æ page 65)*3 For details, please refer to [CURVED CORRECTION] → [ARC]. (Æ page 63)*4 For details, please refer to [KEYSTONE] → [BALANCE]. (Æ page 65)Notef One of [KEYSTONE], [CORNER CORRECTION] and [CURVED CORRECTION] setting value is valid. When [KEYSTONE],[CORNER CORRECTION] or [CURVED CORRECTION] adjustment is finished, you adjust the others, the adjusted valuewill be reset.f Press the button on the remote control when the [KEYSTONE], [CORNER CORRECTION] or [CURVEDCORRECTION] screen is displaying, it will switch to the next adjustment screen.f When the [CORNER CORRECTION] individual adjustment screen is displaying, the individual adjustment screen of the nextcorner can also be displayed by pressing the button.f Correcting up to ±25° for the tilt in the vertical direction and ±30° for the tilt in the horizontal are available for adjustmentswith [KEYSTONE]. However, the image quality will degrade and it will get harder to focus with more correction. Install theprojector so that the correction will be as small as possible.f Screen size will also change when [KEYSTONE] is used to perform various adjustments.f Aspect ratio of the image size may shift depending on the correction.[SHIFT](Only for computer (RGB) signals and YCBCR/YPBPR signals input)Move the image position vertically or horizontally if the image position projected on the screen is shifted even when the relativeposition of the projector and the screen is installed correctly.1) Press as to select [SHIFT].2) Press the button.f The [SHIFT] screen is displayed.3) Press asqw to adjust the position.Orientation Operation AdjustmentVertical (up and down)adjustment.Press the a button. The image position moves up.Press the s button. The image position moves down.ENGLISH - 67Chapter 4 Settings - [POSITION] menu
