Panasonic PT-VX400 Operating Instructions Manual

Also see for PT-VW330E: Command manual Operating instructions

Contents

Panasonic PT-VX400 Operating Instructions Manual Manual pdf 53 page image

SettingENGLISH - 53 SettingsXSubpicture sizeJPress ▲▼ to select [Subpicture size]1 )and then press the button.Press ▲▼ to select one among the2 )positions as below.You can adjust the subpicture position. (thezbottom right, the top right, the top left and thebottom left).Attention[Subpicture size] and [Subpicture position] works onlyzunder P IN P mode.The P IN P function is not available depending on thezinput signals and the selected input terminals.When the input signal(s) is/are incompatible, mark willzbe displayed on the Main/Sub picture.Power managementFor reducing power consumption as well asmaintaining the lamp life, the Power managementfunction turns off the projection lamp when theprojector is not operated for a certain period.Press ▲▼ to select [Power1 )management].Press ► or the button to select one modeamong the items as below.Ready When the lamp has been fully cooleddown, the indicatorchanges to green blinking. In thiscondition, the projection lamp willbe turned on if the input signal isreconnected or any button on thecontrol panel or remote control ispressed.ShutdownWhen the lamp has been fully cooleddown, the power will be turned off.Off [Power management] function is off.TimerJPress ▲▼ to select [Timer] and then1 )press the button.Press ▲▼ to switch between On and2 )Off.When this function is set to [On], the projectorzwill be automatically turned on just byconnecting the AC power cord to a wall outlet.Be sure to turn off the projector properly. If thezprojector is turned off in the incorrect sequence,the [Direct On] function does not work properly.Standby modeThis function can set the electric power when theprojector is standing by.Press ▲▼ to select [Standby mode]1 )and then press the / 80

Related manuals for Panasonic PT-VW330E