ENGLISH -55SettingsLamp powerThis function allows you to change brightness of thescreen.Press ▲▼ to select [Lamp power] and1)then press the Press ▲▼ to select one among the2)modes as below.You can also press the button tozdisplay [Lamp power].AutoBrightness according to the inputsignal.NormalThe lamp power output ismaximum.Eco1The lamp power output is 70%of the Normal mode.Eco2The lamp power output is 53%of the Normal mode.Remote controlThis switching function prevents remote controlinterference when operating several projectors orvideo equipment at the same time.Press ▲▼ to select [Remote control].1)Press ► or the 2)Press ▲▼ to select one among the3)seven codes.This projector provides 7 different remotezcontrol codes: [ALL], [Code 1]~[Code 6].AttentionWhen operating the projector under [ALL] code, you canzoperate several projectors at the same time. If you wantto operate the projector independently, you must switchto other code.When different codes are set on the projector and on thezremote control, any operation cannot be made. In thatcase, switch the code on the remote control to fit thecode on the projector.If the batteries are removed from the remote control for azlong period of time, the remote control code will be reset.SecurityThis function allows you to use the Key lock and PINcode lock function to set the security for the projectoroperation.Press ▲▼ to select [Security].1)Press ► or the 2)access the submenu.Key lockJThis function locks the control panel and remotecontrol buttons to prevent operation by unauthorizedpersons.Press ▲▼ to select the desired items1)as below.Unlocked.Lock the operation of the controlpanel. To unlock, use the remotecontrol.Lock the operation of the remotecontrol. To unlock, use the controlpanel.PIN code lockJThis function prevents the projector from beingoperated by unauthorized persons and provides thefollowing setting options for security.Press ▲▼ to select the desired items1)as below.OffUnlocked.On1Enter the PIN code every timeturning on the projector.On2Enter the PIN code to operatethe projector once the power cordis disconnected; as long as theAC power cord is connected, theprojector can be operated withouta PIN code.AttentionWhenever you change the PIN code lock setting or thezPIN code (the four-digit number), you are required toenter the PIN code. The "1234" is set as the initial PINcode at the factory.Setting
