Panasonic PTDZ8700U - DLP PROJECTOR Operating Instructions Manual

Contents

Panasonic PTDZ8700U - DLP PROJECTOR Operating Instructions Manual Manual pdf 59 page image

POSITION menuENGLISH - 59 SettingsVID AUTO (PRI.)JThe projector identifies the abovementionedVID or S1 signals and displays the picture byautomatically choosing the screen sizes of 4 : 3or 16 : 9 according to the VID if it is detected orS1 signals if a VID is not detected. This function iseffective for S-Video NTSC signals.J THROUGHPictures are displayed without changing theresolution of the input signals.J 16 : 9When standard signals *4 are input, the picturesare displayed with the aspect ratio converted to16 : 9. When wide signals are input *5 , the picturesare displayed without changing the aspect ratio.J 4 : 3When standard signals *4 are input, the picturesare displayed without changing the aspect ratio.When wide signals are input *5 and [4:3] isselected with [SCREEN FORMAT], the aspectratio is changed to 4:3. If [4:3] is not selected with[SCREEN FORMAT], the pictures are reduced sothat they will be in the 4:3 screen without changingthe input aspect ratio.J H FITThe display will use the full width of the screenrange selected with [SCREEN FORMAT]. Whensignals have a vertical aspect ratio that is largerthan the screen aspect selected with [SCREENFORMAT], the pictures will be displayed with theirbottom areas cut off.J V FITThe display will use the full height of the screenrange selected with [SCREEN FORMAT].J HV FITThe pictures are displayed in the full screen rangeselected with [SCREEN FORMAT]. If the aspectratios of the input signals and screen range differ,conversion to the screen aspect set with [SCREENFORMAT] is performed and then the pictures aredisplayed.Standard signals are input signals with an aspect*4 :ratio of 4 : 3 or 5 : 4.Wide-screen signals are input signals with an*5 :aspect ratio of 16:10, 16 : 9, 15 : 9 or 15 : 10.NoteSome size modes are not available for certain types ofzinput signals. For NTSC signals, [DEFAULT] cannot beselected.If an aspect ratio which is different from the aspect ratiozfor the input signals is selected, the pictures will appeardifferently from the originals. Be careful of this whenselecting the aspect ratio.If using this projector in places such as cafes or hotels tozdisplay programs for a commercial purpose or for publicpresentation, note that adjusting the aspect ratio or usingthe zoom function to change the screen pictures maybe an infringement of the rights of the original copyrightowner for that program under copyright protection laws.If conventional (normal) 4 : 3 pictures which are notzwide-screen pictures are displayed on a wide screen,the edges of the pictures may not be visible or they maybecome distorted. Such pictures should be viewed aswith an aspect ratio of 4 : 3 in the original format intendedby the creator of the pictures.ZOOMThis adjusts the size of the projected pictures.Press ▲▼ to select [ZOOM].1 )Press button.2 ) The [ZOOM] screen will be displayed.zPress ▲▼ to select [VERTICAL]/3 )[HORIZONTAL], and press ◄► toadjust.J When [ASPECT] is set to[DEFAULT]Press ▲▼ to select [MODE].1 )Press ◄► to switch [MODE].2 )INTERNALZoom area is the factory defaultsetting of [SCREEN FORMAT] in[SCREEN SETTING].FULLEnlarges the size of the picturesusing the whole of the display areaselected with [SCREEN FORMAT].