Setting date and timeWhen the unit is turned on for the first time, a message asking you to set the date and time will appear.Select [YES] and press the joystick. Perform steps 2 and 3 below to set the date and time._Rotate the mode dial to select _ or O.1 Select the menu. (-> 28)I [BASIC] --_ [CLOCK SET]--_ [YES] 1[ [2 Select the date or time, thenadjust the desired value with thejoystick.• The year will change as follows:2000, 2001 ..... 2099, 2000 ....• The 12-hour system is used to display the time.3 Press the joystick to enter theselection.• The clock function starts at [00] seconds whenthe joystick is pressed.• Changing the date and time display modeSelect the menu. (-> 28)[SETUP] --_ [DATE/TIME] --_ desired displaystyle[DATE] [D/T]l NOV,15,2008 I NOV,15,2008 12:34 PM[OFF]l• Changing the date formatSelect the menu. (-> 28)[SETUP] --_ [DATE FORMAT] --_ desireddisplay style[Y/M/D] 2008.NOV. 15[M/D/Y] NOV. 15.2008[D/M/Y] 15.NOV.20084 Press the MENU button to finishthe setting.• Check the date and time displayed.The date and time function is driven by a built-in lithium battery.If the time display is [- -], the built-in lithiumbattery needs to be charged. Use the followingsteps to charge the battery, and then set thedate and time.To recharge the built-in lithium batteryConnect the AC adaptor or insert the battery tothe unit, and the built-in lithium battery will berecharged. Leave the unit as it is for approx.24 hours and the battery will save the date andtime for approx. 6 months. (Even if the modedial is set to OFF, the battery is still beingrecharged.)31LSQT1337