Panasonic Palmcoder SDR-H40PC Operating Instructions Manual

Contents

This unit will resume recording/pause modeabout 1.7 seconds after the LCD monitor isreopened.• When in quick start standby mode about60% of the power used in recording pausemode is being consumed, so the recordingtime will be reduced._Rotate the mode dial to select _ orO.1 Select the menu. (-> 28)I [SETUP] --> [QUICK START] --> [ON] I2 Close the LCD monitor while themode dial is set to m or O.The status indicator O flashes green and the unitgoes into quick start standby mode.c3different from the scene last recorded. (Whenthe MagicPix function is used, however, thewhite balance of the scene last recorded isretained.)• In the quick start mode, the zoommagnification becomes 2x and the picture sizemay differ from what it was before quick startstandby mode.• If [POWER SAVE] (-) 29) is set to[5 MINUTES] and the unit automatically goesinto quick start standby mode, close the LCDmonitor and then open it again.Reduces the image shaking (jitter) due to handmovement when recording.Rotate the mode dial to select _ orO.Press the O.I.S. button.O.I.S.®3 Open the LCD monitor.The status indicator O lights red and the unit isput into recording pause approx. 1.7 secondsafter it is turned on.To cancel Quick startSelect [SETUP] --> [QUICK START] --> [OFF]• The default setting is on.• Quick start standby mode is canceled ifabout 5 minutes elapsedthe mode dial is switchedthe battery is removed or the AC adaptor isdisconnected• In the quick start mode it may take some timefor automatic white balance to adjust, if thescene being recorded has a light source42LSQT1337The image stabilizer icon [((_))] appears.To cancel the image stabilizer functionPress the O.I.S. button again.• The default setting is on.• In the following cases, the image stabilizerfunction may not work effectively.When the digital zoom is usedWhen the unit is shaken greatlyWhen you record a moving subject whiletracking it