88-4. Installing Batteries1. Remove the cover.2. Insert two AAA alkaline batteries.Put the batteries in with the polarity [+/–] as shown in the figure.3. Gently insert one end of an unfolded paper clip (or a similar object that canfit) into the Reset hole and press the Reset button inside the hole and thenput the cover back on.NOTE• Change the batteries when the display of the remote control gets weak or if it willnot work unless close to the receiver. (Alkaline batteries generally last about one year.)• When changing batteries, always use two fresh batteries of the same make.• If the remote control will not be used for a long period of time, remove the batteries.• Please dispose of batteries appropriately.• After changing the batteries, follow the procedures described below to reset thecurrent time.8-5. Setting the Current TimeAfter changing the batteries and pressing reset, be sure to reset the current time.(When reset is pressed, the current time reverts to [ ])1. Press for two seconds or more.Once the clock displays starts blinking, the clock can be set.2. Set the hour with / of the .If you press and hold the button, the time changes quickly.3. Set the minutes with / of the .If you press and hold the button, the time changes quickly.4. Pressing completes the time setting.• While you are setting the current time, the time display flashes but the colon does not.• If the buttons are not pressed for three minutes while setting the current time,it is set to the displayed time.NOTE• When reset is pressed, the timer settings are deleted.8-6. OperationAuto , Heat , Dry , Cool , FanModels that only provide the cooling function cannot operate in the auto or heating modes.Power : Turn on the power of the indoor unit at least 14 hours before operation.1. Press .2. Press and select from among Auto , Heat , Dry , Cool and Fan .3. Press and select the desired speed.If set to Auto , the fan speed switches automatically.(Auto does not work when in the Fan mode.)4. Press one of the buttons and set the desired temperature.Temperature settings cannot be made when in the Fan mode.Auto Heat Dry / CoolMAX 27 30 30MIN 17 16 182 1,431423CoverReset hole8-5
