Panasonic S-200PE2E5 Technical Data & Service Manual

Also see for S-200PE1E8: Instruction manual Technical data & service manual Technical data & service manual

Contents

Panasonic S-200PE2E5 Technical Data & Service Manual Manual pdf 187 page image

88-9. Operating Multiple In/Outdoor Units Simultaneously (Group Control)Group control works well for providing air conditioning to one,large room with more than one air conditioning units.•••One remote control can operate up to eight indoor units.All the indoor units have identical settings.Set temperature sensing to the indoor unit (Main Sensor).8-10. Using the Remote Control• Point the transmitter of the remote control at the receiver. When the signal is received correctly it will beep once.(It beeps twice only when the unit starts operating.)• The signal can be received at a distance of about 6 meters. This distance should be used only as a guide.It depends on battery strength.• Make sure nothing is between the remote control and the receiver that could block the signal.• Do not leave the remote in direct sunlight, where the wind from the air conditioner can blow directly on it, or nearany other heat source.••Take care not to drop, throw or wash the remote control with water.The signal from the remote control may not be received in rooms withrapid start fluorescent lighting, inverter lights, plasma displays,LCD televisions (monitor), etc. For more information, please contactthe dealer where the product was purchased.Wall Mount Use• Press from the location you wish to mount the remote and makesure the signal is received correctly.• Pull the remote control forward to remove it.Fasten the remotecontrol mount withscrews.Fitting the remotecontrol in themount.Remote controlmount12Put inPressWireless Remote ControlSignal LineIndoor UnitIndoor UnitReceiverChanging a timer setting• Press / for the or the , and then when the timer setting is displayed, press /for the timer again.Canceling a timer setting• If you press [CANCEL], the timer setting is canceled.• If you wish to cancel the setting for either the or the timer, press / or the desired timerand when the scheduled time is displayed, press [CANCEL].Using the same timer setting every day• If you press for 2 or more seconds, “ ” is displayed and the ON timer or the OFF timerwill operate the unit at the same time every day.• If you press again for two seconds or more, “ ” goes off and the timer operates just once.8-8. Adjusting the Wind Direction••Never try to manually move the flap (up-down wind direction plate) that is operated by the remote control.When the unit stops, the flap (up-down wind direction plate) automatically faces downwards.• When the unit is in heating standby, the flap (up-down wind direction plate) faces upward.Also, bear in mind that the flap starts swinging after the heating standby mode is released, but the displayon the remote control indicates Auto Flap during standby heating as well.8-7