Panasonic S-200PE2E5 Technical Data & Service Manual

Also see for S-200PE1E8: Instruction manual Technical data & service manual Technical data & service manual

Contents

Panasonic S-200PE2E5 Technical Data & Service Manual Manual pdf 188 page image

8AddressDisplay on theRemote ControlCZ-RWSC.2Position ofthe Receiver’sAddress SwitchThe position of thereceiver’s addressswitch does notmatter.For 1, 2 and 3, setthe switch on theleft and for 4, 5 and6, to the right.NOTE• Please do not hold the [Emergency Operation] button of the indoor unit down while the indoor unit’sdisplay lamps are blinking one after another.• Make sure to operate while the indoor unit is stopped.• The address of indoor unit is set to “ALL” at the time of the shipment.8-11. For Best ResultsDon’t get the remote control too far away from the receiver.This may cause a malfunction. Be sure to keep the remote control in the same room as the receiver.Point the remote control at the receiver.When the signal is received correctly it will beep one time.Avoid locating the remote control where it is covered, such as behind a curtain.Keep it out in the open.8-12. AddressesIn both multi and single unit installations, when more than one indoor unit is installed in the same room witha compatible remote control, addresses can be set up to avoid crosstalk. By setting the address switches on thereceivers and matching them with the number of addresses on the remote control, up to six indoor units can becontrolled separately with the remote control. (When using units in a flexible combination or operating multipleunits simultaneously, as they are operated at the same time, they cannot be controlled individually.)• These settings are saved in nonvolatile memory in the remote control, so even when its batteries are changed,the settings do not have to be made again.Checking AddressesWhen you press on the remote control, its current address is shown in the display. If this addresscorresponds to the address of a receiver, the buzzer sounds. (If it is on ALL, the buzzer will always sound.)If it is on ALL, it can be operated regardless of receiver addresses. Point the remote control at the receiver youwish to operate and transmit.Matching up AddressesSetting Remote Control Addresses1. If you press and at the same time, “ ” will blink.2. While holding down, every time you press , it cycles from ALL 1 2 3...6 ALL.Set it to the receiver address switch of the indoor unit you wish to operate.3. When you release , the address that was displayed is set.When you do this, if it corresponds to the receiver’s address setting, the buzzer sounds.8-8